Copter: pass eeprom start to Mission constructor

ArduCopter/ArduCopter.pde

@@ -353,7 +353,7 @@ AP_AHRS_DCM ahrs(ins, barometer, g_gps);
 static bool start_command(const AP_Mission::Mission_Command& cmd);
 static bool verify_command(const AP_Mission::Mission_Command& cmd);
 static void exit_mission();
-AP_Mission mission(ahrs, &start_command, &verify_command, &exit_mission);
+AP_Mission mission(ahrs, &start_command, &verify_command, &exit_mission, MISSION_START_BYTE, MISSION_END_BYTE);
 
 ////////////////////////////////////////////////////////////////////////////////
 // Optical flow sensor
@@ -759,7 +759,7 @@ static void pre_arm_checks(bool display_failure);
 ////////////////////////////////////////////////////////////////////////////////
 
 // setup the var_info table
-AP_Param param_loader(var_info, WP_START_BYTE);
+AP_Param param_loader(var_info, MISSION_START_BYTE);
 
 #if MAIN_LOOP_RATE == 400
 /*

ArduCopter/defines.h

@@ -296,24 +296,14 @@ enum FlipState {
 // Centi-degrees to radians
 #define DEGX100 5729.57795f
 
-
-// EEPROM addresses
-#define EEPROM_MAX_ADDR         4096
-// parameters get the first 1536 bytes of EEPROM, remainder is for waypoints
-#define WP_START_BYTE 0x600 // where in memory home WP is stored + all other
-                            // WP
-#define WP_SIZE 15
-
 // fence points are stored at the end of the EEPROM
 #define MAX_FENCEPOINTS 6
 #define FENCE_WP_SIZE sizeof(Vector2l)
-#define FENCE_START_BYTE (EEPROM_MAX_ADDR-(MAX_FENCEPOINTS*FENCE_WP_SIZE))
+#define FENCE_START_BYTE (HAL_STORAGE_SIZE_AVAILABLE-(MAX_FENCEPOINTS*FENCE_WP_SIZE))
 
-#define MAX_WAYPOINTS  ((FENCE_START_BYTE - WP_START_BYTE) / WP_SIZE) - 1 // -
+// parameters get the first 1536 bytes of EEPROM, mission commands are stored between these params and the fence points
-                                                                          // 1
+#define MISSION_START_BYTE   0x600
-                                                                          // to
+#define MISSION_END_BYTE     (FENCE_START_BYTE-1)
-                                                                          // be
-                                                                          // safe
 
 // mark a function as not to be inlined
 #define NOINLINE __attribute__((noinline))