ensure we are lined up, or we are at less than 0.5 of radius before we
switch to QRTL. This fixes the case where the stopping distance is
greater than the radius, prevening us from switching to QRTL while not
lined up with the landing point
allow for delayed takeoff, and takeoff at a particular time (for swarm
takeoff)
also check for takeoff command in landing sequence arming check
this allows for takeoff->land->disarm->delay->arm->takeoff->land
missions
when a user sets a passby distance we should calculate the turn point
based on the extrapolated distance, not the original waypoint
also simplify the passby logic using offset_bearing()
this is equivalent to copters WP_NAVALT_MIN parameter for takeoff. Not
implemented for land yet
this is useful for vehicles with significant GPS velocity noise on
takeoff, preventing dragging the landing gear
this fixes a case where we can get false positive on the landing
detector for quadplanes.
The issue happens if we cross the LAND_DESCEND to LAND_FINAL threshold
while pilot repositioning is active, with stale information in
landing_detect.lower_limit_start_ms as we don't run should_relax() in
LAND_DESCEND
when we arm in guided mode then enter a special guided_wait_takeoff
state. We keep motors suppressed until one of the following happens
1) disarm
2) guided takeoff command
3) change to AUTO with a takeoff waypoint as first nav waypoint
4) change to another mode
while in this state we don't go to throttle unlimited, and will refuse
a change to AUTO mode if the first waypoint is not a takeoff. If we
try to switch to RTL then we will instead use QLAND
This state is needed to cope with the takeoff sequence used by QGC on
common controllers such as the MX16, which do this on a "takeoff"
swipe:
- changes mode to GUIDED
- arms
- changes mode to AUTO
when RC_OPTIONS has been changed to not check throttle for arming then
treat this like a sprung throttle for quadplane throttle suppression
in auto-throttle modes, and only unsuppress when throttle goes above
trim+dz
this helps when the aircraft has gone into a landing sequence due to a
failsafe before it is armed. Arming while in the landing sequence is
very unlikely to be what the user wants
We decided to remove this after 4.2 was out in favour of
MAV_CMD_DO_SET_HOME which has been available since 2015.
The gcs-maintainers list was notified in Feburary.
Iampete1
Peter Barker
Andrew Tridgell
Henry Wurzburg
Mirko Denecke
Randy Mackay
murata
TunaLobster