* Previously the loop was written over channels, now it is over motors
* the correct channel for that motor is determined by ch_of_mot.
* ch_of_mot is defined correctly based on the config_channels macros.
* Every use of MSK_CH_n changed to _BV(CH_n)
* Easier to read, and will allow CH_n to be parameterized without needing
a separate macro expansion for the MSK value.
New order for motors!! Based on Hein's testing. See Wiki for updated layouts
Simplified the CUT_MOTORS section of the code.
git-svn-id: https://arducopter.googlecode.com/svn/trunk@3026 f9c3cf11-9bcb-44bc-f272-b75c42450872
Added Yaw control when descending in Alt hold
lowered kP & kD for Alt hold a tad
Adjusted RTL behavior to do speed control up to 4m to home, then go into Loiter
Fixed issue with AUTO not getting proper input.
Added Limit to high side of motors
git-svn-id: https://arducopter.googlecode.com/svn/trunk@2874 f9c3cf11-9bcb-44bc-f272-b75c42450872
changed Yaw to be offset from current angle to avoid the kick back.
Made minimum motor speed user settable, upped to 13% (130)
tweaked alt hold D to be higher and P to be slightly lower.
git-svn-id: https://arducopter.googlecode.com/svn/trunk@2579 f9c3cf11-9bcb-44bc-f272-b75c42450872
Added Octo Support
Fixed Loiter issue regarding Yaw towards loiter location
Added Yaw control alternative for testing
decreased Yaw deadband to +-5°
revved to 2.0.10
git-svn-id: https://arducopter.googlecode.com/svn/trunk@2392 f9c3cf11-9bcb-44bc-f272-b75c42450872
Pat Hickey
Jason Short
Jason Short
Jason Short
Olivier ADLER
Andrew Tridgell
jasonshort
tridge60@gmail.com