This removes a lot of the ArduPlane specific cruft left over from the
initial Rover import from ArduPlane, plus fixes a bunch of serious
bugs. For example, the rover was unable to use either compass or gps
for heading - it used just gyros!
There is still a lot of cruft left, but this at least gives a bit
better basis for future work
Arduplane: increased MAVLINK delay to 6s to reduce the chance of xBee bricking
Ardurover: increased MAVLINK delay to 6s to reduce the chance of xBee bricking
Added option (hold roll to full right + SW7 ON/OFF) to init_home during the wp_list reset
Add ROV_SONAR_TRIG (default = 200 cm) - tested by Franco
Restart_nav() added and heading bug correction, tested OK in the field
RTL then stop update - Tested OK in the field
Added SONAR detection for obstacle avoidance
Signed-off-by: Jean-Louis Naudin <jlnaudin@gmail.com>
Fixes compatibility for APM2. Also a significant update to the battery monitoring code: We previously had monitoring modes for individual cell voltages for 3 and 4 cell lipos. These have been removed as they were never really supported (the cell voltages were computed but were not reported or recorded anywhere). Also, some clean-up/prep work was done for supporting monitoring 2 separate battery packs. The CLI battery and current monitoring tests were consolidated into 1 test.
This is useful for switching back to the mode indicated by the control
switch after a failsafe or fence breach. I was just changing modes
each time, but it is far more elegant to have a spring loaded switch
for "I am ready to take control again", rather than continually
changing modes.
* This enables the BMA085 driver for compatibility with beta boards.
* The CLI_SLIDER_ENABLED=DISABLED line does not need to be in the makefile.
config.h takes care of this default.
This patch will boost the target airspeed as necessary to keep the ground speed above a parameter value - param_min_groundspeed. Airspeed is still limited to FBW-max. Setting min_groundspeed to zero (default) disables the feature.
It is fully configurable with the mission planner, there is no need to change
the source code to adapt to your setup.
It needs more testing, but the SIL is not working for me.
Andrew Tridgell
rmackay9
Craig Elder
Robert Lefebvre
Jean-Louis Naudin
Doug Weibel
Michael Oborne
Pat Hickey
Amilcar Lucas