36cc832931
Copter: guided_posvel run update_z_controller at 400hz
10 years ago
da629ce976
Copter: minor format fix
10 years ago
f5fd89833d
Copter: update YAW_LOOK_AHEAD to use inav velocity direction
10 years ago
e5b6cf9966
Copter: use circular limit on tilt angle for arm check
10 years ago
85b0a18f61
Copter: fix MNT param description
...
extra underscore was appearing in the parameter descriptions on the web
10 years ago
276b2dcf5e
Copter: move lost copter check to separate function
...
Also run from scheduler instead of from arm/disarm stick checks
Run at 10hz instead of 1hz
soundalarm_counter to uint8
Disable if equivalent aux switch is setup
Remove SEVERITY_LOW message because the GCSs never print these anyway
10 years ago
5bee93cba3
Copter: Lost copter alarm through sticks
10 years ago
b7a6e3bf2c
Copter: fix update_thr_average to run at 100hz
...
Committed by Randy on Julien's behalf
10 years ago
64629914a4
Copter: fix RTL alt when no using Rally points
10 years ago
0545185218
Copter: RTL at no less than 2m above home alt
10 years ago
4311cd4e7a
Copter: add logging for CH6 parameter tuning
...
Logs CH6 tuning values to a new PTUN log struct, specific to
APM::Copter at this point
10 years ago
2baf79ee7a
Copter: remove TUNE param descr for AHRS Yaw/RP kP
10 years ago
cb2427ef9e
Copter: removed special cases for DCM gain changes on arm/disarm
...
copter no longer uses DCM, so it doesn't need these special cases
10 years ago
1aa696bc10
Copter: Implement Stop Mode
10 years ago
8e4268ddd3
Copter: Initial creation of control_stop file
10 years ago
66c7090f00
Copter: fix compile warnings by converting .f to .0f
10 years ago
b57437042e
Copter: fix compile warnings for unused functions
10 years ago
94dc973c29
Copter: update ARMING_CHECK parm description
10 years ago
6e623bce28
Copter: remove optical flow init failure message
...
the sensor only becomes healthy once it has received data which will
take a few seconds after initialisation meaning this failure message
will always be displayed even when the sensor is fine.
10 years ago
37e8d1a338
Copter: PosController alt limit from fence and EKF
10 years ago
3719ea53e4
Copter: add range finder status to extended status msg
10 years ago
5e359c977f
Copter: replace range finder health with status
10 years ago
1ff443d667
Copter: add rangefinder pre-arm check
10 years ago
133b8f5ad7
Copter: Allow EKF to pull data from range finder object
10 years ago
a52d554a10
ArduCopter: Handle GPS Data Injection
10 years ago
704e75d140
ArduCopter: Remove kruft from old RTK driver
10 years ago
bfd24801ea
Copter: minor format fix
10 years ago
7cf883a61c
Copter: increase the telemetry receive function rate to 400Hz
...
gimbal loop runs at 100Hz so to respond in time the gcs_check_input must run at a faster rate, the process are asyncronus
10 years ago
5de15464b6
Copter: add call to send digicam configure messages from a mission item
...
Also add log_picture to separate logging and feedback from
the do_take_picture function so that it can be used when pictures
are triggered from a mission command
10 years ago
a27f383612
Copter: remove duplicate IMU/ATT logging
...
Previously IMU and ATT data could be logged at both a high rate
and a low rate. This patch makes it skip the low rate logging
if the high rate is enabled
10 years ago
06b3935beb
Copter: LOG_BITMASK parameter def get All+FastIMU, All+FastATT
10 years ago
dfb720bab6
Copter: rename FULL_IMU logging to IMU_FAST
...
This naming is consistent with the earlier ATTITUDE_FAST option and
clarifies that it's the rate that's increased rather than the content.
10 years ago
2dbff9c544
Copter: remove scheduler table for 100hz CPUs
...
We only support high performance CPUs capable of 400hz
10 years ago
5a45de5e00
Copter: IMU full-rate logging LOG_BITMASK flag
10 years ago
1c6c03b0eb
Copter: firmware back to V3.3-dev
10 years ago
9a025024b5
Copter: use LowPassFilterVector3f for land detector accel filter
10 years ago
eafbd94d51
Copter: run land detector at 400hz
10 years ago
f93ff2d3ec
Copter: use new lowpass filter
10 years ago
ca66b51ba9
Copter: Autotune parameter update
10 years ago
93d5c39248
Copter: add filter for the land detector
...
Individual access filtering will be replaced with a single 3-axis low pass
filter in the near future
10 years ago
1fcb0f4d53
Copter: pos_control param prefix shortened to PSC
10 years ago
49d3357e1d
Copter: add z-axis accel logging
10 years ago
b50f065cab
Copter: use relax alt hold controllers
10 years ago
91a03ae0e7
Copter: add PILOT_THR_FILT and call set_throttle_out functions with that value
10 years ago
b27b9dd86e
Copter: use new throttle interface
10 years ago
0cff3a4292
Copter: fixup Windows newlines
10 years ago
ee91be66cf
Copter: Update of land detector
10 years ago
2b5fb850dd
Copter: Autotune adjustments
10 years ago
f2993edc36
Copter: move MSG_BATTERY2 higher in select
...
No functional change
10 years ago
7dbd6c8509
ArduCopter: Enable MSG_BATTERY2 through Mavlink
...
For allow to show battery_2 voltage and current on GCS.
10 years ago
Jonathan Challinger
Randy Mackay
svefro
Julien Dubois
David Dewey
Andrew Chapman
Andrew Tridgell
Robert Lefebvre
Tom Pittenger
Paul Riseborough
Niels Joubert
Arthur Benemann
Jaime Machuca
Peter Barker
Leonard Hall
Dario Lindo Andres