This allows us to consider enabling UAVCAN_RGB_LED as a more general
default, as it won't consume one of our limited backend slots if UAVCAN
is not enabled.
allow faster rates synchronized to the loop rate
synchronize 1Khz and use Betaflight definition for prescaler
adjust dshot bitrates
don't allocate IC DMA if already allocated
cancel DMA pulses correctly
try really hard to align pulses with push() by making each dshot pulse event driven
We should only need to do a single PAYLOAD_SIZE check for each mavlink
backend now.
- stop iterating over all channels, only do instantiated mavlink
backends
- if we don't have space for a statustext on a channel, break
immediately and don't do remaining texts
- resposibility is now on the GCS_MAVLINK backend for sending texts
- that's a timing change
- only iterate over entries actually in the queue rather than maximum
queue size
- it's likely to be the full length anyway as we don't expire things
from the queue and most setups will have full channels
with the new ChibiOS revision we were configuring for newer revisions
of the H7, which meant that we changed the ADC config. This broke ADC
readings on revX and revY H7 MCUs.
This PR fixes it in two ways:
1) change ChibiOS config to assume XY config chips
2) use 16 bit ADC for H7, which means the chip rev doesn't matter,
and also gives us 16x the resolution for ADC readinga, so we can
read smaller voltage and current values
set_wp_destination clear yaw target
limit velocity and acceleration based on track slope
add is_active() and remove unused reached_spline_destination
init accepts desired speed
set_kinematic_limits uses current speed limits instead of defaults
add time compression to prevent target moving too fast for air
implement alternative spline
remove vel-target-length
set_wp_destination always calculates this leg
set_kinematic_limits moved to scurve
fix origin speed after spline segment
spline terrain following fix
handle s-curves with mismatching alt types
fix set_spline_destination_next
add update_track_with_speed_accel_limits
Change to next waypoint at corner apex
use scurve advance along track
remove unused definitions and out-of-date todo
set_spline_destination_next sets fast_waypoint
scurve origin speed set from spline target velocity
fixup takeoff delay
Peter Barker
anbello
Andy Piper
Iampete1
Andrew Tridgell
Jacob Walser
Michael du Breuil
PYBrulin
Rishabh
willpiper
Randy Mackay
Leonard Hall