This removes a lot of the ArduPlane specific cruft left over from the
initial Rover import from ArduPlane, plus fixes a bunch of serious
bugs. For example, the rover was unable to use either compass or gps
for heading - it used just gyros!
There is still a lot of cruft left, but this at least gives a bit
better basis for future work
Arduplane: increased MAVLINK delay to 6s to reduce the chance of xBee bricking
Ardurover: increased MAVLINK delay to 6s to reduce the chance of xBee bricking
Added option (hold roll to full right + SW7 ON/OFF) to init_home during the wp_list reset
Add ROV_SONAR_TRIG (default = 200 cm) - tested by Franco
Restart_nav() added and heading bug correction, tested OK in the field
RTL then stop update - Tested OK in the field
Added SONAR detection for obstacle avoidance
Signed-off-by: Jean-Louis Naudin <jlnaudin@gmail.com>
Fixes compatibility for APM2. Also a significant update to the battery monitoring code: We previously had monitoring modes for individual cell voltages for 3 and 4 cell lipos. These have been removed as they were never really supported (the cell voltages were computed but were not reported or recorded anywhere). Also, some clean-up/prep work was done for supporting monitoring 2 separate battery packs. The CLI battery and current monitoring tests were consolidated into 1 test.
This is useful for switching back to the mode indicated by the control
switch after a failsafe or fence breach. I was just changing modes
each time, but it is far more elegant to have a spring loaded switch
for "I am ready to take control again", rather than continually
changing modes.
* This enables the BMA085 driver for compatibility with beta boards.
* The CLI_SLIDER_ENABLED=DISABLED line does not need to be in the makefile.
config.h takes care of this default.
Andrew Tridgell
Bill Bonney
Randy Mackay
Craig Elder
Robert Lefebvre
Jean-Louis Naudin
Doug Weibel
Michael Oborne
Pat Hickey