Separate prediction and correction steps are required to provide an up to date yaw estimate using IMU prediction before it may be required by SelectMagFusion() whilst still doing the velocity update after GPS data haw been pulled from the buffer by SelectVelPosFusion()
AP_NavEKF3: Fix typo in comment
AP_NavEKF3: Use uint32_t data type for msec timers
AP_NavEKF3: Misc msec timer fixes
Fix wrapping bug.
Use common timestamp.
AP_NavEKF3: Format fixes - remove tabs
AP_NavEKF3: Fix typing and wrap issue on time comparison
ArduCopter: Request lane or yaw reset switch sooner
ArduCopter: rework ekf check to use separate yaw reset request
ArduCopter: Rework EKF failsafe
During flight operations it is the deviation in position of the vehicle that matters during most scenarios.
t patch ensures that an EKF fail-safe will be triggered when the position inconsistency exceeds check limits in addition to either a bad mag or velocity innovation.
This will stop velocity noise triggering an early fail-safe when electromagnetic interference is present.
Enables the yaw to be reset in flight to a value estimated from a specialised yaw estimator. This allows faster recovery if taking off with a bad magnetometer and also allows yaw alignment and GPS use to commence in-air when operating without any yaw sensing.
AP_NavEKF2: Add missing accesor functions for default airspeed
AP_NavEKF3: fix failure to arm with EK3_MAG_CAL = 7
AP_NavEKF3: Fix failure to arm when not using magnetometer
AP_NavEKF3: Reduce yaw drift when EK3_MAG_CAL = 7
AP_NavEKF3: Add emergency yaw reset using a Gussian Sum Filter estimate
AP_NavEKF3: Reduce default minimum GPS velocity noise for Copters
Enables fail-safe to be set with more sensitivity and improves tracking accuracy.
Origin values were set using typical GPS performance for receivers on sale 6 years ago. Receiver performance has improved since then.
AP_NavEKF3: Prevent constant mag anomaly yaw resets
Prevents constant magnetic anomaly induced resets that can be triggered when flying with vehicle generated magnetic interference.
Allows for two resets per takeoff. Allowance for two resets is required, becasue a large ground based magnetic yaw anomaly can cause a sufficiently large yaw innovation that two resets in close succession are required.
AP_NavEKF3: Add option to fly without magnetometer
AP_NavEKF3: Rework emergency yaw reset logic
Use a separate external accessor function to request the yaw reset.
Allow reset requests to remain active for a defined period of time.
Tidy up reset function to split out accuracy check.
AP_NavEKF3: Fix vulnerability to lane switch race condition
Prevents the situation where a lane switch results in a lane being selected that does not have the correct yaw. This can occur if the primary lane becomes unhealthy before the external failsafe monitor has time to react.
AP_NavEKF3: Fix EKF_MAG_CAL = 6 behaviours
Fix bug causing the yaw alignment to be performed at startup before the GSF had a valid estimate.
Fix bug causing emergency yaw message to be output for a normal reset.
Fix vulnerability to reported negative yaw variance.
Remove duplicate timer checks.
AP_NavEKF3: Update EK3_MAG_CAL documentation
AP_NavEKF3: Relax yaw gyro bias convergence check when not using mag
AP_NavEKF3: Reduce yaw drift in hover with no yaw sensor
Uses the GSF yaw estimate if available which is better than the EKF's own yaw when no yaw sensor is available.
Randy Mackay
Paul Riseborough
Andrew Tridgell
Rishabh
Tatsuya Yamaguchi
Peter Barker
bugobliterator