Added Tilt_Compensation to Params,
deprecated RTL_Land_Enabeled
RTL_Approach_alt is not int16_t, -1 means do noting. 0 means land, >1 means hover to that altitude after timeout.
Added note about -1 to disable feature
Set RTL_Atl by default after reaching home in case we're at the wrong alt.
increased speed of Yaw rotation for WPs
this enables MNT_* parameter control of the camera mount code. It also
fixes the conversion of calculated angles between degrees and
integers, and fixes stabilised mount control when yaw control is not
available.
this allows us to use the MS5611 barometer at its full 100Hz sample
rate (80Hz for pressure, 20Hz for temperature). The pressure and
temperature values are averaged between reads without adding any
latency. Previously the driver would throw away values between
readings
This also fixes a race condition in reading from the SPI bus that
could lead to bad values from the barometer
added a new RTL function that goes into Loiter, first, checks if we have reached RTL_Altitude, then enters WP mode to come home.
Removes Approach mode. Uses Auto_Approach value to decide if we should land or descend to a certain altitude
fix config panel value change detection
add loiter_ to AC config screen
Add praram name to Friendly param, and exception ignoring.
fix param file note line
intergrate andrews gimbal config.
fix any possible log appending issues
remove old cli planner on connect
modify speech to not crash on windows mono
this fixes several problems with reading analog sources:
- we were getting poor values because we didn't wait long enough for
an analog source to settle
- we wasted a lot of CPU cycles waiting for conversions
- we were not taking averages over many samples, which we did with
the old AP_ADC driver on the APM1
Jason Short
Andrew Tridgell
Michael Oborne
rmackay9
Adam M Rivera