add filtered second and third harmonics and log them
make sure we use all of the gyro samples available on each axis rather than skipping
separate gyro update from fft start to minimize time in fast loop
add FFT_HMNC_PEAK to allow users to select which noise peak and which axis will be tracked.
make sure the self-test runs once and display the results
report self-test failure reason. make sure self-test runs for all windows.
always give logging a chance to run at IO_PRIORITY
add log message documentation
make sure the engine still runs even when the arming check has been disabled
record last FFT update time and cycle time and fallback to throttle estimate when update is too old
delay for longer in FFT thread between cycles to cope on F4
try really hard to get a viable frequency estimate
change range on MAXHZ/MINHZ to reflect that 50Hz is actually quite dangerous
swap the center peak for one of the shoulders if there is temporarily a closer match with the frequency trend
when FFT is disabled still log harmonic notch frequency
use distance matrix to find most appropriate peak
use a median filter to remove outliers before filtering
discount peaks that are relatively too low in energy
make sure harmonic fit is tracked for both potential targets
convert all gyro buffers to ObjectBuffer<float> for lock-free access
run all FFT steps inside the FFT thread
calculate cycle time and loop delay correctly
drop samples when the ring buffer is full
Andy Piper
6da1f3bf2e