px4_autopilot/ROMFS/px4fmu_common/init.d/666_fmu_q_x550

#!nsh

echo "[init] 666_fmu_q_x550: PX4FMU Quad X550 with PWM outputs"

#
# Load default params for this platform
#
if param compare SYS_AUTOCONFIG 1
then
	# Set all params here, then disable autoconfig
	param set MC_ATTRATE_P                0.14
	param set MC_ATTRATE_I                0
	param set MC_ATTRATE_D                0.006
	param set MC_ATT_P                    5.5
	param set MC_ATT_I                    0
	param set MC_ATT_D                    0
	param set MC_YAWPOS_D                 0
	param set MC_YAWPOS_I                 0
	param set MC_YAWPOS_P                 0.6
	param set MC_YAWRATE_D                0
	param set MC_YAWRATE_I                0
	param set MC_YAWRATE_P                0.08
	param set RC_SCALE_PITCH              1
	param set RC_SCALE_ROLL               1
	param set RC_SCALE_YAW                3

	param set SYS_AUTOCONFIG 0
	param save /fs/microsd/params
fi

#
# Force some key parameters to sane values
# MAV_TYPE     2 = quadrotor
#
param set MAV_TYPE 2
 
#
# Start MAVLink
#
mavlink start -d /dev/ttyS0 -b 57600
usleep 5000

#
# Start PWM output
#
fmu mode_pwm

#
# Load mixer
#
mixer load /dev/pwm_output /etc/mixers/FMU_quad_x.mix

#
# Set PWM output frequency
#
pwm -u 400 -m 0xff

#
# Start common for all multirotors apps
#
sh /etc/init.d/rc.multirotor
 
# Exit, because /dev/ttyS0 is needed for MAVLink
exit