Jenkins: HIL temporarily tolerate ERRORs during 'uorb top' (long running command)

- on older boards if the sensor auto cal completes while this is
running it causes a brief sensor timeout

.ci/Jenkinsfile-hardware

@@ -793,7 +793,7 @@ void checkStatus() {
   sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "top once"'
   sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "uavcan status" || true'
   sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "uorb status" || true'
-  sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "uorb top -1 -a"'
+  sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "uorb top -1 -a" || true'
   sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "ver all"'
   sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "work_queue status"'
   // stop logger
@@ -862,7 +862,7 @@ void runTests() {
 void printTopics() {
   sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "ls /obj"'
   sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "uorb status"'
-  sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "uorb top -1 -a"'
+  sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "uorb top -1 -a" || true'
 
   // these are for casually inspecting the system, output failure doesn't matter
   sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "listener actuator_armed" || true'