boards: set SENS_TEMP_ID defaults

.ci/Jenkinsfile-hardware

@@ -918,6 +918,7 @@ void printTopics() {
   sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "listener estimator_status_flags"'
   sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "listener estimator_wind"'
   sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "listener event"'
+  sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "listener heater_status"'
   sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "listener input_rc"'
   sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "listener led_control"'
   sh './Tools/HIL/run_nsh_cmd.py --device `find /dev/serial -name *usb-*` --cmd "listener log_message"'

boards/cuav/x7pro/init/rc.board_defaults

@@ -15,6 +15,8 @@ param set-default BAT2_A_PER_V 24
 # Enable IMU thermal control
 param set-default SENS_EN_THERMAL 1
 
+param set-default SENS_TEMP_ID 6946850
+
 # Set Camera trigger pins to 13/14
 param set-default TRIG_PINS_EX 12288
 

boards/cubepilot/cubeorange/init/rc.board_defaults

@@ -12,4 +12,6 @@ param set-default BAT2_A_PER_V 17
 # Disable IMU thermal control
 param set-default SENS_EN_THERMAL 0
 
+param set-default -s SENS_TEMP_ID 2621474
+
 set IOFW "/etc/extras/cubepilot_io-v2_default.bin"