The user-defined literals for milli- and microseconds
should have argument names matching their units. The
current argument names 'seconds' is probably an oversight.
Refering to the refernece manual:
Tx queue operation is configured by programming FDCAN_TXBC.TFQM to 1. Messages
stored in the Tx queue are transmitted starting with the message with the lowest message
ID (highest priority). **In case that multiple queue buffers are configured with the same
message ID, the queue buffer with the lowest buffer number is transmitted first**
Tx FIFO operation is configured by programming FDCAN_TXBC.TFQM to 0. Messages
stored in the Tx FIFO are transmitted starting with the message referenced by the get index
FDCAN_TXFQS.TFGI. After each transmission the get index is incremented cyclically until
the Tx FIFO is empty. The Tx FIFO enables transmission of messages with the same
message ID from different Tx buffers in the order these messages have been written to the
Tx FIFO
The issue will be cancelation:
The FDCAN supports transmit cancellation. To cancel a requested transmission from a
dedicated Tx buffer or a Tx queue buffer the Host has to write a 1 to the corresponding bit
position (= number of Tx buffer) of register FDCAN_TXBCR. Transmit cancellation is not
intended for Tx FIFO operation.
But there is nothing preventing it. This seems to indicate it will
work. When a transmission request for the Tx buffer referenced by the get index is canceled, the
get index is incremented to the next Tx buffer with pending transmission request and the Tx
FIFO free level is recalculated. When transmission cancellation is applied to any other Tx
buffer, the get index and the FIFO free level remain unchanged.
PX4 uses banks of 8 outputs as a logical structure. Boards that have
more outputs than 8 get multiple instances. This is an arbitrary choice
that helps with overall structure and enables the mixing of different
device classes (like FMU, IO or UAVCAN).
- fully respect datasheet quality and shutter metrics for mode changes
- use MOTION pin for scheduling if available
- log light mode
- refactor common enable LED code
- respect read and write time delays
Send battery status (ghst_telemetry). Apply factors to show correct values of volts, amps and mAh. Change ghost protocol code to follow more MISRA C++ guidelines.
subsscription for services responses and request and helps the usage of fixed
port subscribers Furthermore move register autconfigure logic from Uavcan.cpp
to NodeManager
Also add commented-out code for use with PR-16808
(MixingOutput + output_control)
Bench-tested PWM output on a Pixracer via UAVCANv1 ESC commands from a
Pixhawk 4.
Daniel Agar
David Sidrane
Lorenz Meier
Beat Küng
Morten Fyhn Amundsen
Dima Ponomarev
PX4 BuildBot
jciberlin
Peter van der Perk
CUAVcaijie
Igor Mišić
斯东Stone
Jacob Crabill
JacobCrabill