Now running into issues with running out of stack frame memory
For now I'm going to leave the relevant code in so it's at least
readable, but in its current state it will not compile
nxp/s32k14x:board_identity: Return length of mfguid
nxp/s32k14x:CAN driver
nxp/s32k14x:Drver Added ABORT on error
canbootloader:Use N words for first word
canbootloader:Ensure the up_progmem API always defined
These changes remove the two code paths to updates (forceupdate and update) and try to reboot and bootload IO independent of its state, wether it is in bootloader mode already, safety switch is off or if it is in "nominal state" (running and safety on). This ensures that there are no conditions where user error or boot sequence can prevent a successful upgrade. The only state where an upgrade will not be done is if the system is fully armed.
Supporting direct down loads from ROMFS with preferece give to the
files fould on the SD card first. This will allow a user to provide
an updated uavcan firware on the SD card, and there is no overhead
of coping files from the ROM FS to the SD card.
- new heater_status logging message
- run continously at low rate until configured sensor is found
- fix px4io fd bugs (fd open/close/ioctl must be same thread)
- new IMU driver structure with state machine (no sleeps in bus thread)
- verify all configured registers and trigger reset on failure
- detect if DIO1 or DIO2 are actually connected for data ready interrupt usage
- don't use CRC-16 on burst transfers except for verified lots
- libcanard in PX4/Firmware (0c6cf6cb99): cde6703474
- libcanard current upstream: 55938c51cf
- Changes: cde6703474...55938c51cf
55938c5 2020-12-29 Pavel Kirienko - Merge pull request #160 from UAVCAN/readme-fix
1c91c49 2020-12-29 Pavel Kirienko - Improve the example in README, fix#159
JacobCrabill
David Sidrane
Daniel Agar
Lorenz Meier
jciberlin
alexklimaj
Alex Mikhalev
mcsauder
Jari Nippula
PX4 BuildBot
Peter van der Perk