- include icm20948 on most boards by default
- create more test variants for default boards near flash limit (cuav_nora_test, cuav_x7pro_test, holybro_durandal-v1_test)
I don't think we should be broadcasting by default as we haven't done
that in the past. This suddenly spams the network with a lot of
messages, and leads to confusing situations in offices where there are
multiple PX4 SITL and QGC intances are open.
PX4 uses banks of 8 outputs as a logical structure. Boards that have
more outputs than 8 get multiple instances. This is an arbitrary choice
that helps with overall structure and enables the mixing of different
device classes (like FMU, IO or UAVCAN).
nxp_ucans32k146:Relocation for Bootloader
nxp_ucans32k146:can_boot enable CAN
nxp_ucans32k146:Save Space use Non Optimize memcpy
nxp_ucans32k146:Increase to 24K
nxp/ucans32k146:Canbootloader LED Driver
nxp_ucans32k146:Can bootloader shut down CAN
nxp_ucans32k146:Use NVMEEPROM for Paramaters
nxp_ucans32k146:Use bootloader AppDescriptor
px4 mtd:Support onchip emulated eeprom
These changes remove the two code paths to updates (forceupdate and update) and try to reboot and bootload IO independent of its state, wether it is in bootloader mode already, safety switch is off or if it is in "nominal state" (running and safety on). This ensures that there are no conditions where user error or boot sequence can prevent a successful upgrade. The only state where an upgrade will not be done is if the system is fully armed.
Previously, we did not set a remote port which meant that the default
remote port 14550 was used. This meant that the mavlink instance
talking to the gimbal was interfering with the connection to the ground
station (on 14550).
Daniel Agar
Jaeyoung-Lim
斯东Stone
Chris Lovett
Beat Küng
Bastian Jäger
TSC21
Silvan Fuhrer
Julian Oes
Lorenz Meier
David Jablonski
Kevin Dominic Merkel
Nicolas MARTIN
Gonçalo Atanásio
garfieldG
JacobCrabill
David Sidrane