- sitl_gazebo in PX4/Firmware (1ee08da9c4): 651ca351fd
- sitl_gazebo current upstream: 371e7c36c3
- Changes: 651ca351fd...371e7c36c3
371e7c3 2018-04-10 korotkoves - udp port for each model instance from options file
376258d 2018-04-17 korotkoves - change file format to use common and model specific parameters
b4b7245 2018-01-17 korotkoves - function to load parameters for each model from xml file
- analysed_logdata: add filter_fault_status check to test_results
dictionary to prevent a missing entry exception
- analyse_logdata: fix one-off errors of list indices due to python
non-inclusive end indices
When SYS_USE_IO was disabled, px4io would not start and thus there was no
RC. SYS_USE_IO=0 is interesting on Quads to avoid the IO and reduce output
latency.
Tested on Pixhawk 1 and Pixhawk 4
- Catch the case where the case where the driver gets stuck because nothing is received by +SBDRB
- Add a mutex for the rx buffer
- Stop the standby loop if a mode change is already scheduled
- Move publishing the telemetry status from the IridiumSBD driver to the mavlink instance
- In the commander use the iridiumsbd_status message for heartbeat in case of a high latency link
- Move positive acknowledge to the mavlink instance
- Add a failed acknowledge in the commander if no high latency link exists
* Add return to land to mission
This method uses the planned mission for rtl. If a landing sequence
is present it will continue the mission and land. If not it will
fly back the mission and loiter/land at the home position.
These hard coded paths assume all Nuttx targets are ARMv7-M targets. Updating them to use ${CONFIG_ARCH} and ${CONFIG_ARCH_FAMILY} instead allows for the architecture defined by the incoming Nuttx defconfig to be correctly targeted.
- just use external mag, if they run together the sensor_mag_0 topic gets
corrupted even though they publish on different instances
- added sleep at two places, they resolve weird boot problems like params
not being read correctly...
Signed-off-by: Roman <bapstroman@gmail.com>
- ecl in PX4/Firmware (9e6449570a58587b7dd0f4919ea9d6f0a52f5239): cb63f16d48
- ecl current upstream: 50631e5d98
- Changes: cb63f16d48...50631e5d9850631e5 2018-05-21 Daniel Agar - geo remove use of DBL_EPSILON
- DriverFramework in PX4/Firmware (381d3ccd577484a57e555ec9ad6166249d590140): e06222dd15
- DriverFramework current upstream: 410e9fc4e7
- Changes: e06222dd15...410e9fc4e7
410e9fc 2018-05-18 Roman - mpu9250: set internal gyro dlpf frequency to 92 Hz
PX4 Jenkins
johannes
Daniel Agar
Beat Küng
acfloria
Hamish Willee
Lorenz Meier
mcsauder
Anthony Lamping
Sander Smeets
mcsauder
Joshua Whitehead
DanielePettenuzzo
Roman