Channels belonging to a certain timer were not all grouped together.
This is required by the .first_channel_index and .last_channel_index data
members.
We introduce a new mixer geometry to solve the problem.
- nuttx in PX4/Firmware (4b356c91f2be41dfdadb38270fab01ddb337d3c7): 7b36108b54
- nuttx current upstream: fdf1837077
- Changes: 7b36108b54...fdf1837077
fdf1837077 2020-02-07 Peter van der Perk - [BACKPORT] S32K add support for Nxp drone boards (#224)
f479b26c98 2020-02-07 Peter van der Perk - [BACKPORT] imxrt added missing i2c prescale mask
26dd187034 2020-02-07 Peter van der Perk - [BACKPORT] Kinetis renamed TJA1100 to TJA110X registers
I don't think we're quite ready for codecov reporting on every PR. The initial report seems to work fine, but there are various issues that result in bogus reporting when additional commits are added or after a rebase.
Use yawrate setpoint from weather vane only if velocity setpoint is small
(smaller than half the cruise velocity)
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
- remove gloabl variable and instead give back forward_thrust from function
- give back increased vertical thrust from fct thrust_compensation_for_tilt()
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
-move pusher assist functionality into vtol_type class and adapt it to also
work for tiltrotor VTOLs (pitch rotors down to accelerate forward)
-for tiltrotor: compensate for lost lift due to tilt by increasing the throttle
-enable pusher / tiltassist also in altitude mode
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
This is done to test the recovery function of the estimator in case
of divergence or sudden extreme hover thrust change.
Also specify seed of random generator
with measurement noise auto-tuning
The purpose of this estimator is to improve land detection and vertical
velocity feedforward
Recovery strategy:
This is required when the setpoint suddenly changes in air or that the
EKF is diverging. A lowpassed test ratio is used as a trigger for the recovery logic
Also, a lowpassed residual is used to estimate the steady-state value
and remove it when estimating the accel noise to avoid increasing the
accel noise when the redisual is caused by an offset.
- it does nothing useful
- increases boot time by 2 seconds on pixhawk 4 due to a poll timeout:
IST8310 on I2C bus 3 at 0x0e (bus: 100 KHz, max: 400 KHz)
WARN [ist8310] ERROR: TIMEOUT 2
* add support for unmanned underwater vehicles:
* airframe uuv_generic + uuv_hippocammpus including mav_type = 12 for submarines
* mixer for UUVs with X-shaped thruster setup similar to quadcopter
* add module uuv_att_control for underwater robot attitude control
* add rc.uuv_defaults/apps for autostarting e.g. ekf2 and uuv_att_control app
* Add param for software flow ctl on 3DR radios
* Dont reset telemetry type on radio timeout
* Treat 3DR radio as generic link type
* Rename 3DR to SiK radio
Beat Küng
bresch
David Sidrane
Daniel Agar
stmoon
PX4 BuildBot
Silvan Fuhrer
CarlOlsson
Ricardo Marques
Daniel Duecker
Hamish Willee
Nico van Duijn
SalimTerryLi
fnoop
Roman Dvořák
JaeyoungLim
Travis Bottalico