The failsafe from rng height to baro height should occur after a reset
to baro triggered by the controlHeightSensorTimeouts function and not in
the fusion selector.
Until now, the EKF was fusing baro measurements between rng updates if
the range finder ODR was slower than the EKF update rate. This is not
the case anymore as the height reset occurs after 5 seconds.
The unit test has been extended to show this behavior.
* EKF: centralize range finder tilt check
* Ekf-control: do not double check for terrain estimate validity
isRangeAidSuitable can only return true if the terrain estimate is valid
so there is no need for an additional check
* range_finder_checks: restructure the checks to avoid early returns
There is now only one clear path that can lead to the validity being
true.
Furthermore, if the _rng_hgt_valid is true, we can trust it and we don't
need for additional checks such as tilt.
The case where we need to provide fake measurements because the drone is
on the ground and the range finder data is bad is already handled
in "controlHeightFusion" so there is no need to hack the range finder
checks with that.
* Add Sensor and SensorRangeFinder classes
The purpose is to encapsulate the checks for each sensor in a dedicated
class with the same interface
* SensorRangeFinder: encapsulate in estimator::sensor namespace
* EKF: rename _sensor_rng to _range_sensor
* Range checks: include limits in valid range
* RangeChecks: update comment in the continuity checks
* RangeChecks: move more low-level checks in functions
Also move setTilt out of the terrain estimator, this is anyway protected internally
to not compute cos/sin if the parameter did not change.
* Sensor: remove unused virtual functions
Those are not required yet but can still be added later
* SensorRangeFinder: re-organise member variables
Also rename getRangeToEarth to getCosTilt
* SensorRangeFinder: split setSensorTilt and setCosMaxTilt functions
* SensorRangeFinder: Add a few unit tests
- good data
- tilt exceeded
- max range exceeded
* SensorRangeFinder: set hysteresis in us instead of ms
* SensorRangeFinder: Add more tests
* SensorRangeFinder: update continuity, hysteresis and stuck tests
* SensorRangeFinder: rename variables
* SensorRangeFinder: get rid of "delayed" specification
From the SensorRangeFinder class point of view, it's not relevant to
know if the data is delayed or not
* SensorRangeFinder: move time_last_valid out of stuck check
* SensorRangeFinder: rename file names to sensor_range_finder
* SensorRangeFinder: address Kamil's comments
* SensorRangeFinder: Add more tilt tests
* SensorRangeFinder: store current tilt offset
This is to avoid recomputing cos/sin functions at each loop
bresch
Kamil Ritz