This is the case for boards with digital readout, like v5x, but still
enable the battery_status module for external analog driver options.
An alternative would be to not run battery_status depending on config.
SD is on SPI3 - correct pin mapping
Fix DMA Mapping for all SPI and RX DMA on U[S]ART RX
Fix Memory MAP SRAM size
Removed unused GPIO
Used proper I2C definitions
Ensure Watchdog is configured for debugging
Fixed FLASH param definitions
Removed unedded SPI init
matek_gnss-m9n-f4:Correct Board ID and Size
Build order SJF
Added Support for F40x
Split the px4_layer into user and kernel space libraries. Add some stubs for
user-space (e.g. version) where an interface to the kernel needs to be added
Use posix-versions for cpuload.cpp and print_load.cpp for userspace; these link to nuttx internals. This functinality could be built on top of posix (e.g. procfs) interfaces
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
Since uORB is split into kernel and userspace parts, it is no longer possible to just
link uORB into px4_platform, which is used in both kernel and user side.
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
For NuttX protected or kernel build, the prebuilds can't contain libraries which are
different for kernel and user-space in protected/kerenl builds
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
This adds the env option PX4_FUZZ which runs the LLVM libFuzzer which
throws random bytes at mavlink_receiver using MAVLink messages over UDP.
The MAVLink messages that are being sent are valid, so the CRC is
calculated but the payload and msgid, etc. are generally garbage, unless
the fuzzing gets a msgid right by chance.
As I understand it, libFuzzer watches the test coverage and will try to
execute as much of the code as possible.
- Allocate and free the node name in uORBDeviceNode.
- Add protected build support by de-allocating the name with kmm_free, when
running in kernel side. strdup allocates from the kernel heap in NuttX kernel
space.
- Remove the CDev::unregister_driver_and_memory(), it is no longer used
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
In NuttX protected build there are separate work queues in kernel and user sides.
pthreads are only available in user side, so use tasks and kthreads for
memory protected builds.
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
- use NuttX gdb script for nxthreads and thread backtrace
- update jlink_gdb_backtrace and jlink_debug_gdb helper targets to use
NuttX gdb script
- Debug/PX4 fix "perf" divide by zero
- Debug/PX4 add "dmesg"
dmesg was locking the console buffer, then writing to stdout (a pipe in
the case of the MAVLink shell).
This might block, waiting for mavlink to read from the pipe. If however
mavlink tries to write to the console at that time, the lock is already
taken.
This patch avoids nested locking by using a separate buffer.
Beat Küng
David Sidrane
Daniel Agar
Peter van der Perk
Jukka Laitinen
Julian Oes
PX4 BuildBot
Igor Mišić