Symmetric buffers allow a much more reliable QGC Wifi telemetry connection especially when (virtual) joysticks are used. (this board does not provide RX DMA on UART 4 as its timer does DSHOT).
The noise spectral density, NSD, (square root of power spectral density) is a
continuous-time parameter that makes the tuning independent from the EKF
prediction rate.
NSD corresponds to the rate at which the state uncertainty increases
when no measurements are fused into the filter.
Given that the current prediction rate of EKF2 is 100Hz, the
same tuning is obtained by dividing the std_dev legacy parameter by 10:
nsd = sqrt(std_dev^2 / 100Hz)
The noise spectral density, NSD, (square root of power spectral density) is a
continuous-time parameter that makes the tuning independent from the EKF
prediction rate.
NSD corresponds to the rate at which the state uncertainty increases
when no measurements are fused into the filter.
Given that the current prediction rate of the wind estimator is 1Hz, the
same tuning is obtained with the same values as before.
1. Rename *_header_s structs to *_s, since the _header postfix is not
helpful
2. Rename the "key" string variables in the message structs to
"key_value_str" as the string actually contains not just the key but the
key and value pair information
3. Add comments on other uLog messages to clarify use (need more
improvement / can be even more simplified)
* sih: Move sih out of work queue
This reverts commit bb7dd0cf00.
* sih-sim: Enable sih in sitl, together with lockstep
* sih-sim: new files for sih: quadx and airplane
* sih: Added tailsitter for sih-sitl simulation
* sitl_target: Added seperate target loop for sih
* jmavsim_run: Allow jmavsim to run in UDP mode
* lockstep: Post semaphore on last lockstep component removed
* sih-sim: Added display for effectively achieved speed
* sih: increase stack size
* sih-sim: Improved sleep time computation, fixes bug of running too fast
* sitl_target: place omnicopter in alphabethic order
Co-authored-by: romain-chiap <romain.chiap@gmail.com>
Co-authored-by: Matthias Grob <maetugr@gmail.com>
- documentation of units, params, returns, and descriptions for variables and methods
- rename ambiguous or erroneous state variables
- remove unused or unecessary input arguments to functions
- remove ugly header white space
The safetyButtonHandler() reports that the safety statatus
changed on the first loop iteration when safety is disabled which makes
sense to inform the system that safety is off but the tune for the user
should not be played because it interrupts the startup tune.
They cause problems with building px4_msgs in ROS2 Humble Hawksbill and removing them fixes the issue.
Co-authored-by: Agata Barcis <agata.barcis@tii.ae>
This corrects the board definition to use the proper polarity
for the brick power valid signal, thus allowing the board to
detect the battery and monitor it properly.
Igor Mišić
Daniel Agar
achim
Matthias Grob
bresch
Junwoo Hwang
fury1895
David Sidrane
PX4 BuildBot
Thomas Debrunner
Thomas Stastny
Silvan Fuhrer
PX4BuildBot
Beat Küng
Jaeyoung-Lim
abarcis
BA-ED
Thomas Watson
Mark Sauder