It scales the yawspeed setpoint arbitrarily by default with 0.5.
This makes no sense because when you give a setpoint of 1rad/s then
you expect the setpoint to get executed. If you want manual yawspeed
response to be less agressive on the stick use the scaling parameter
for the stick MPC_MAN_Y_MAX.
This commit is an attempt to fix a race condition happening on takeoff
between the land detector and the multicopter position controller.
Previously, an auto-takeoff leads to the following events:
1. A takeoff setpoint is given.
2. The thrust setpoint spikes because we don't enter smooth takeoff yet.
3. The land detector detects a takeoff because of the high thrust.
4. The position controller sees the landed state transition and
initiates the smooth takeoff. Thrust goes back down.
5. Depending on control gains the takeoff is successful or fails
if the smoothing takes too long which causes thrust to be too low, so
the land detector detects land again.
The two obvious problems with this are:
- The intermittent spike.
- The failed takeoff because of the smoothing leads to a delay..
With this change, the logic for a takeoff detection is moved from the
land detector to the position controller.
The events are now:
1. A takeoff setpoint is given.
2. The position controller detects the takeoff setpoint and initiates
the smooth takeoff.
3. As thrust ramps up, the land detector detects the take off.
In the same way, we now detect the intent to takeoff in manual,
altitude, control, position control in the position controller instead
of in the land detector.
As ASC use a non-standard UART for mavlink it is necessary check for
the board name and set SYS_AUTOSTART to initialize mavlink on the
right interface otherwise there is no way to change the SYS_AUTOSTART.
Lorenz Meier
Hyon Lim
Matthias Grob
Julian Oes
Daniel Agar
Beat Küng
mcsauder
Martin Trgina
David Sidrane
Lucas De Marchi
José Roberto de Souza
Lorenz Meier
James Goppert