When running in HITL mode, pwm_out_sim publishes actuator_outputs.
px4io unconditionally publishes the uOrb actuator_outputs. When HITL
is configured, the px4io copy of the uOrb has all zeros.
The result is that there are two publications, one valid, and one
all-zeros. This causes the HIL_ACTUATOR_CONTROLS mavlink message
to be incorrect (all-zeros) and the SERVO_OUTPUTS_RAW mavlink
message to be inconsistent, as it takes the data from one or the
other uOrb randomly each cycle.
The fix is to let px4io know that HITL is in effect when it is
started, and modify px4io to suppress publication in this case.
This is a bigger more complicated fix than I would like, but I
think it is conceptually correct.
Signed-off-by: Nik Langrind <langrind@gmail.com>
The Addition of PX4_ARCH_DCACHE_LINESIZE is fundamentally wrong.
It asserst that an STM32F4 has a cache and it does not.
This should be #if defined() on CONFIG_ARMV7M_DCACHE
Durandal:Fix PLL settings
durandal-v1:Move I2C123, I2C4 to HSI.
Not liking using HSI but, F7 has, and in reality there is no
requerment for accuracy.
durandal-v1:board config set 400kHz on card probe
durandal-v1:Board SDMMC Clock Not greater then 25 mHz
durandal-v1:Fix PLL3 configuration typo and value
CI build config for holybro_durandal-v1
durandal-v1:Kconfig - add knob to ensure ARCH_MATH_H is kept
Upstream changes added ARCH_HAVE_MATH_H to protect from archs
without math.h from causing isses for users setting
CONFIG_ARCH_MATH_H and getting errors. PX4 provides a math.h
and we need CONFIG_ARCH_MATH_H set. So this Selects
ARCH_HAVE_MATH_H perserving CONFIG_ARCH_MATH_H a defconfig
Track master LED removal
durandal-v1: bmi055 -> bmi088
bmi088 is what the board uses
durandal-v1:add PX4IO support
durandal-v1 rc.board_sensors: start baro
durandal-v1: remove segway module
durandal:Run at 480 Mhz
durandal-v1: build thermal control module
durandal-v1: enable IMU thermal control by default
durandal-v1:Track upstream adc start moved to rc.board_sensors
durandal-v1:Track upstream mavlink start moved to rc.board_mavlink
- Startup was broken due to unnecessary cyclic check probably introduced during transition to work_queues
- Module never used other than on Teal One which had a hacky heater input GPIO, this enables usage on general boards
drivers: heater: reduce verbosity and simplify commandline options
- We prefer the linux way of only reporting errors and staying quiet when everything is functioning as designed
- Most of the commandline options just read out the values of the system parameters, and one can just check the parameter values directly.
sensor_params: make thermal control parameters system parameters
heater_params: make thermal control parameters system parameters
drivers: heater: remove pin control hacks
- px4_arch_configgpio(GPIO_HEATER_OUTPUT) directly inits the heater pin to OFF, and as a PUSHPULL (TTL totem pole) OUTPUT
drivers: heater: set default device ID to 0
Daniel Agar
David Sidrane
Jannik Beyerstedt
Claudio Micheli
Nik Langrind
Mohammed Kabir
Beat Küng