TSC21
145e7387fb
posix: start the microRTPS client in sim every time the module is available
4 years ago
Daniel Agar
500c45e798
uORB: Subscription check if uORB::Manager instance is valid
...
- this is necessary if uORB::Subscription is used with static storage
duration
4 years ago
David Sidrane
9377b02c58
Track NuttX Timer changes
4 years ago
David Sidrane
05bdef867d
Track NuttX syslog change
4 years ago
David Sidrane
f3624c172c
kinetis pinirq:Use inttypes
4 years ago
David Sidrane
6e5a86b6fe
dshot:Matched signature to drv_pwm_output.h
4 years ago
David Sidrane
dc23c85085
px4/common:mtd Use inttypes
4 years ago
David Sidrane
84dd8839a2
i2c_spi_buses:Track NuttX change to getopts avoid name collision
...
NuttX #defined optarg and getopt to move to TLS. This fixes the
name collision.
4 years ago
AlexKlimaj
dddd2c3297
drivers/distance_sensor: New Broadcom AFBR-S50LV85D distance sensor driver
...
* Basic Broadcom AFBR-S50 driver using vendor API and binary blob https://github.com/Broadcom/AFBR-S50-API
* fix ARK Flow paw3902 rotation
4 years ago
David Sidrane
9c8e95db8d
NuttX w/NXP contrib for FlexCAN fixes
4 years ago
echoG
6bc09138c1
Adding BatMon smart battery as a module and refactoring SMBUS based SBS 1.1 spec to a library
4 years ago
Daniel Agar
47b9016f5e
I2CSPIDriverBase: print rotation and i2c address if set
4 years ago
achim
66dbc1e25f
Update rc.board_arch_defaults
...
logger doesn't start at all up to 4k buffer
4 years ago
achim
fd2161b6bf
Update rc.board_arch_defaults
...
logger doesn't start at all up to 4k buffer
4 years ago
achim
1ab7943940
Update rc.board_arch_defaults
...
Logger doesn´t start at all with 4k buffer
4 years ago
David Sidrane
32e92ba817
Revert:Pull downs - bad levels cause motor spins
4 years ago
Daniel Agar
806b462935
px4_work_queue: increase UART stack
4 years ago
Jukka Laitinen
34de392425
Add compiler cmake files for RISC-V (rv64gc) targets
...
This adds the basic support for riscv64-unknown-elf compiler amd rv64gc ISA
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
4 years ago
Jukka Laitinen
935253357a
nuttx compilation: Don't assume "arm" to enable risc-v compilation
...
Replace "arm" by "${CONFIG_ARCH}"
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
4 years ago
Jukka Laitinen
675a5a2b2c
bootloader: change flash_cache addresses to uintptr_t
...
To fix comilation errors on 64 bit platforms
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
4 years ago
Jukka Laitinen
64d264b49a
bootloader: Move chip specific things under chip specific folders
...
- move systick.c under chip specific sources
- move do_jump into chip specific main.c as arch_do_jump
- wrap flash writes to "arch_flash_write" and implement in chip specific main.c
- add bootloader TOC check
- sync image_toc.h with the version currently in use with old bootloader
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
4 years ago
Daniel Agar
c3884b5bc1
fake_imu (formally fake_gyro) updates for testing gyro filtering
...
- fake_imu now publishes sine sweeps over 10 seconds
- accel is also published so that fake IMU can be selected when the only option
4 years ago
Peter van der Perk
60a083b662
canbootloader clear pending systick interrupts
4 years ago
Daniel Agar
ecf2cd3afb
CAN node STM32F7 support and Freefly RTK GPS CAN node
4 years ago
Daniel Agar
ad0482155e
ROMFS: reduce LOGGER_BUF default to 8 kB on older boards
4 years ago
David Sidrane
69e0c2fc10
px4:platform support SPI configuration selection on HW REV
4 years ago
David Sidrane
541697d193
NuttX Backports Fixing SDIO/SDMMC Data Timeouts
...
stm32, F7 and H7
4 years ago
David Sidrane
8d82560308
NuttX Backports
...
[BACKPORT] binnfmt:Fix return before close ELF fd
stm32h7: serial: use dma tx semaphore as resource holder
[BACKPORT] stm32h7:Serial Add RX and TX DMA
[BACKPORT] drivers/serial: fix Rx interrupt enable for cdcacm
[BACKPORT] stm32h7:Allow for reuse of the OTG_ID GPIO
[BACKPORT] stm32f7:Allow for reuse of the OTG_ID GPIO
4 years ago
David Sidrane
3d166d3279
PWM:Add Channel mask to up_pwm_servo_arm & up_pwm_servo_deinit
4 years ago
David Sidrane
d5b60f7002
NuttX with WIP OTG_ID
4 years ago
David Sidrane
362db92515
Define PX4_MAKE_GPIO_INPUT_PULL_DOWN
4 years ago
David Sidrane
dcbfc9de2d
io_timer:Fixed imposible logic
4 years ago
Daniel Agar
3b7ce61901
px4_work_queue: increase wq:rate_ctrl stack slightly
4 years ago
David Sidrane
cd2aceb363
stm32_common:board_reset Fix reboot -b broke by canbootloader
4 years ago
Beat Küng
0a98c5a7f4
Subscription: fix ChangeInstance
4 years ago
JacobCrabill
cc81c7d49e
poor-mans-profiler: Add documentation
...
Now sets the GDB serial device to the path of a DroneCode Probe by
default, with option command-line option override.
A few usage instructions added to the top of the file.
4 years ago
Daniel Agar
f9d8c613b0
px4_work_queue: increase nav_and_controllers stack
4 years ago
David Sidrane
96d0755afd
NuttX with SDMMC Backport
4 years ago
David Sidrane
5e73fe588e
NuttX with SRAM4-heap-bp
4 years ago
Beat Küng
e9370c658a
nuttx cmake: include upload.cmake if it exists (same as on posix)
4 years ago
Daniel Agar
7314b69adc
cmake: fix jlink_flash_uavcan_bin helper
4 years ago
David Sidrane
7f2566dd8a
NuttX STM32H7 16 bit SPI fixes + ADIS16470 updates for proper 16 bit mode in burst
4 years ago
David Sidrane
d9d832c568
NuttX with BACKPORT libc/stdio: Preallocate the stdin, stdout and stderr
4 years ago
Daniel Agar
ea902e7f38
systemcmds/tests: split out individual module test commands
4 years ago
David Sidrane
55abe48925
NuttX with BDMA enable fix backpork
4 years ago
Daniel Agar
5f6832e101
px4_work_queue: increasae UART stack
4 years ago
Beat Küng
e2cd39bf6c
micro_hal: use inline methods instead of #define's
...
Fixes errors in the form of 'error: statement has no effect'
4 years ago
Dongoo Lee
32012cb3ee
for cmake option GENERATE_ROS_MODELS to make ROS sdf models
4 years ago
David Sidrane
833501dee6
stm32h7:adc fix temperature sensing
4 years ago
Daniel Agar
8f242ec444
cmake: add jlink_flash_uavcan_bin helper
4 years ago