- added gazebo VTOL tailsitter debug target
- improved jmavsim debug target and helper tasks to work properly (build and launch directly instead of through the jmavsim_run.sh script)
- improved output console handling for helper tasks (eg gazebo and jmavsim build and run, followed by cleanup after debug)
- added miniterm.py as a task
- nuttx in PX4/Firmware (22a005c9f4): 2d7920055f
- nuttx current upstream: 398a59aaa4
- Changes: 2d7920055f...398a59aaa4
398a59aaa4 2019-11-29 David Sidrane - [BACKPORT] stm32f7:ethernet: Add some delays so that ifup() does not hog the CPU.
- if less than 6 sides are calibrated, keep the existing calibration and
update the offsets and scales
- if 2 sides are calibrated, estimate the offsets only (as this is enough
if a full calibration was done already, and the problem is not
constrained enough to estimate scales and offsets)
So it is independent from the number of configured sides.
Previously, each side would take longer if less than 6 sides were
calibrated.
Also fixes a bug: calibration_sides was used before it was updated, leading
to different behavior on consecutive calibrations with <6 sides.
Fixes a serious bug in combination with the HMC5883 driver (also used for
HMC5983): this driver estimates a scale in MAGIOCCALIBRATE and applies it.
The calibration routine does the calibration with that scale applied, and
then overwrites it, without considering it in any way.
Most other mag drivers only do some measurements and perform some checks
in MAGIOCCALIBRATE (but the result is just ignored).
It's not required to take that many samples, 1 second is enough.
This is confirmed by looking at the standard deviation over 10 calibrations:
it is in the same order as with 20 seconds (the effect of temperature
increase has a bigger effect).
Daniel Agar
PX4 BuildBot
daniele
David Sidrane
Beat Küng
RomanBapst
baumanta
Matthias Grob