If the hardware support RESET lockout that has nArmed ANDed with VBUS
vbus_sense may drop during a param save which uses
BOARD_INDICATE_EXTERNAL_LOCKOUT_STATE to prevent external resets
while writing the params. If we are not armed and nARMRED is low
we are in such a lock out so ignore changes on VBUS_SENSE during this
time.
Once we have valid input we should use that and not overwrite our
update_result with the result from other inputs, otherwise the
automatic selection does not actually work.
This behavior means that only the first update will be used if there are
several sources updating in the same cycle.
It was a mistake to mix these two together, it is simpler to implement the boardctl interface
for the protected build, if the boardctl ioctls are different
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
This adds an ioctl interface for NuttX protected build, allowing
system calls from user space to kernel for uORB, HRT and crypto
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
Weak authority on a axis is currently defined as: none of the actuators have an
effectivness on this particular axis larger than 0.05.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
* Navigator: enable DO_CHANGE_SPEED for outside of mission
- update _mission_cruising_speed_mc/_fw also if DO_CHANGE_SPEED command
is received outside of mission (e.g. while Loitering doing an Orbit)
- if vehicle is in AUTO_LOITER when receiving the change speed, then immediately
apply it by doing a reposition without updating any other field than cruising_speed
and cruising_throttle
-when RTL is activated reset the cruising speed and throttle
* Navigator: reset cruise speed and throttle to default when VTOL-transitioning
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
-pass flag EffectivenessUpdateReason into effectiveness, indicating if there was an external
update or not. Reasons for external updates are:
-config changes (parameter)
-motor failure detected or certain redundant motors are switched off to save energy
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
When building uORB for NuttX flat build, or for some other target, everything
works as before.
When building uORB for NuttX protected or kernel build, this does the following:
- The kernel side uORB library reigsters a boardctl handler for calls from userspace
and services the boardctl_ioctls by calling the actual uORB functions
- For user mode binaries, the uORBManager acts as a proxy, making boardctl_ioctl calls to the
kernel side
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
- mavlink in PX4/Firmware (9457e7b25c4fa51f5ccc0bd887760e910926ba8a): 311eee010b
- mavlink current upstream: 4b0558d0d1
- Changes: 311eee010b...4b0558d0d1
4b0558d0 2022-02-11 Andrew Tridgell - added CANFD_FRAME and CAN_FILTER_MODIFY messages
7f032afe 2022-02-10 Daniel Agar - Apply suggestions from code review
9379a601 2022-02-06 Andrew Tridgell - common: added MAV_CMD_CAN_FORWARD and CAN_FRAME
David Sidrane
Julian Oes
Igor Mišić
murata
Daniel Agar
Justin
Jukka Laitinen
Silvan Fuhrer
Jaeyoung-Lim
Charles Cross
Yannick Fuhrer
Roman Bapst
PX4 BuildBot
bresch