- set measurement of first sample to -1 to indicated that the data
is not valid
- give an estimate of the sensor variance based on the sensor resolution
and experiments
Signed-off-by: Roman <bapstroman@gmail.com>
Move RC and DL failsafe actions handling from navigator to commander (credits to @AndreasAntener)
Separate manual kill switch handling via manual_lockdown to prevent override and release of software lockdown by RC switch
Other changes:
Add failsafe tune
Fix LED blinking for Pixracer
Return back support for rc inputs in simulator but now it is configurable via cmake
This disables the safety switch when Pixracer is configured. It does not change existing setups and it can be re-enabled after. This might be the more sensible default for a racing board.
this fixes a race condition between the DMA completion handler
updating registers in px4io and the mixer used for handling the
override state. The register set code could set r_page_servos[]
between the time when pwm_limit_calc() is called and the servos are
actually output.
- Run in a single ssh command
- Allow to update firmware when mavlink-routerd had already been
stopped
- Be resilient to another daemon interfering the communication by
reading/writting to the UART
- Print OS, BIOS nad FPGA version
- Other channels are irrelevant since they aren't physically
connected. Avoid the I2C transaction to get invalid data
- Port the driver to use only one address, as it should be
- Minor changes here and there
- Add test() method to read the latest value - helpful during
debugging.
Measure the battery voltage of Aero RTF kit will be done by FPGA
and read by AeroFC using I2C bus.
The protocol is a little bit odd, it have different I2C slave
address for each "register", in future the FPGA RTL will
have a protocol more similar to other I2C sensors.
Also Aero RTF don't have a ADC line to measure current consumption.
Steps to debug:
* Run gazebo (or any other sim) server and client viewers via the terminal: `make posix_sitl_default gazebo_none_ide`
* In your IDE select `px4_<mode>` target you want to debug (e.g. `px4_iris`)
* Start debug session directly from IDE
This approach significantly reduces the debug cycle time because simulator (e.g. gazebo) is always running in background and you only re-run px4 process which is very light.
Lorenz Meier
devbharat
Roman
Sander Smeets
Daniel Agar
Anton Matosov
James Goppert
Lorenz Meier
Andrew Tridgell
Lucas De Marchi
José Roberto de Souza
Michael Schaeuble
Matthias Grob