Also add commented-out code for use with PR-16808
(MixingOutput + output_control)
Bench-tested PWM output on a Pixracer via UAVCANv1 ESC commands from a
Pixhawk 4.
Now running into issues with running out of stack frame memory
For now I'm going to leave the relevant code in so it's at least
readable, but in its current state it will not compile
nxp_ucans32k146:Relocation for Bootloader
nxp_ucans32k146:can_boot enable CAN
nxp_ucans32k146:Save Space use Non Optimize memcpy
nxp_ucans32k146:Increase to 24K
nxp/ucans32k146:Canbootloader LED Driver
nxp_ucans32k146:Can bootloader shut down CAN
nxp_ucans32k146:Use NVMEEPROM for Paramaters
nxp_ucans32k146:Use bootloader AppDescriptor
px4 mtd:Support onchip emulated eeprom
nxp/s32k14x:board_identity: Return length of mfguid
nxp/s32k14x:CAN driver
nxp/s32k14x:Drver Added ABORT on error
canbootloader:Use N words for first word
canbootloader:Ensure the up_progmem API always defined
The drag is based on max_acc/max_vel, which means that increasing the
maximum velocity leads to slower braking (at the same starting speed).
Especially a combination of small max_acc (slow responsiveness) with high
max_vel led to an exceedingly high braking distance.
This improves that while still being smooth.
Previous horizontal position noise was a white Gaussian noise with std=0.8m
It results in a noise with high frequencies too high making some ekf
position tests fail (test ratio to allow arming).
The new noise values are below real GPS errors but as theses errors are
generally low frequency, so they cannot be modeled with a white noise.
JacobCrabill
David Sidrane
Beat Küng
Matthias Grob
Daniel Agar
Ryan Johnston
Nicolas MARTIN