Took the existing uavcan_stm32 driver and replaced all bxCAN code with
the equivalent for FDCAN following ST Reference Manual RM0433.
Note: There is still a bug somewhere in regards to FDCAN2 (probably
incorrect setup of the message RAM? Not sure.) But (FD)CAN1 is fully
functional (Classic CAN only, no CAN-FD).
Also TODO: Configure CAN filters. Right now there are no filters; all
incoming messages are accepted.
- remove all remaining IOCTLs for accel and gyro and handle all calibration entirely in sensors module with parameters
- sensor_accel and sensor_gyro are now always raw sensor data
- calibration procedures no longer need to first clear existing values before starting
- temperature calibration (TC) remove all scale (SCL) parameters
- gyro and baro scale are completely unused
- regular accel calibration scale can be used (CAL_ACC*_xSCALE) instead of TC scale
- accel & gyro FIFOs enabled
- FIFO watermark on data ready interrupt
- sensor side filtering completely disabled
- gyro now respects `IMU_GYRO_RATEMAX` (up to 2 kHz)
- saves a few % cpu (at default rate)
- matrix in PX4/Firmware (18f14ebefad29873ddeef6396c7c3a728c90b996): 2bee0d078c
- matrix current upstream: 674bd99f3b
- Changes: 2bee0d078c...674bd99f3b674bd99 2020-06-11 kamilritz - Add operator* and operator/ for slice with type
38b3acc 2020-06-11 Nicolas MARTIN - fix conjugate_inversed comment
A parameter spcifies what the redundancy level for 5V rail supply
needs to be and a check makes sure that it's available before
taking off such that the user is aware of a broken or disconnected
redundant power module.
- ecl in PX4/Firmware (af11fa456d7282e324d662a452c71ae85ee59d9b): b3dc06d0cb
- ecl current upstream: 38cbd1a182
- Changes: b3dc06d0cb...38cbd1a18238cbd1a 2020-06-09 Matthias Grob - AlphaFilter: prevent setParameters division by zero
b7d54b5 2020-06-04 RomanBapst - gps: fixed filter initialization bug around gps - do not gps reference altitude to zero in case gps checks pass before the filter initialized - reset the filtered gps position and position derivative filters in case we are in air or there is movement on the ground
8f533cb 2020-06-03 bresch - terrain_estimator: fix sensor aid selection
821e1fa 2020-06-03 bresch - terrain_estimator: add unit tests
aa96fa6 2020-06-03 bresch - Random style fixes in the code
5d6a72e 2020-06-03 bresch - sensor_simulator: add possibility to set GPS position rate
Minimum requirement to use: set IMU_GYRO_RATEMAX to 400.
Logging rate of a single topic: ~85 KB/s. If multiple should be logged,
a really good SD card has to be used.
- at start perform full sensor signal path reset and wait for max time
- issue full sensor reset on any error
- only allocate DRDY perf counter if GPIO is available
- allow running faster than accel ODR (safe limit of 2 kHz in place)
Beat Küng
Matthias Grob
Daniel Agar
TSC21
JacobCrabill
hanyang2013212
JaeyoungLim
bresch
dino
PX4 BuildBot
Ricardo Marques
RomanBapst