The startup file rc.board is copied to the build/../genromfs folder
after the pruning of the files happened. Thus, about 2000 bytes of
comments and whitespace were included in the ROMFS.
This commit moves pruning of the files in ROMFS to a separate cmake
custom command which happens after the ROMFS files have been copied and
the extra files have been added.
Testing showed that this change only affected the rc.board file as
expected.
tone_alarm was started before the parameters were loaded, and the first
tune was played before that as well. CBRK_BUZZER was then read as default,
ignoring the user-configured value.
We now start tone_alarm after we load the parameters. Note that a
previously published startup tone or SD card error will still be played.
* added a parameter for enabled the smart battery
* start tel1 and tel2 at 921600 and max rate
* turned up the max tx rate on mavlink streams for telem1 and telem2
* turned off mavlink stream for tel1 in 4250_teal. This is connected to TX1 FTDI UART and has issues.
* moved check to 4250 board ID to start mpu9250s for Teal airframe into fmuv4 rc.board.
* Integrated preliminary ICM20948 support into MPU9250 driver.
Fixed temperature conversion for MPU9250/ICM20948.
* Included missing check for PX4_I2C_OBDEV_MPU9250 in main.cpp.
* Added explicit bus for internal MPU9250 on Pixhawk 2.1 to avoid implicit start
of an externally attached device with wrong orientation.
The PX4BuildBot extracted the comments from the lines following
the class line which says "Plane" as the class. To avoid the
confusion for the bot I moved the comment further down.
* The X-UAV Mini Talon airframe with the new type Plane V-Tail uses the new AAVVTWFF_vtail mixer.
The new mixer is derived from the AAVVTWFF mixer and is a generic V-Tail mixer. I left the flaps and wheel although there are no flaps and wheels on the mini talon to keep it generic. The airframe configuration is derived from the Albatross A-Tail.