* drivers, magnetometer: added ak09916 driver to support the mag driver emulated by the Here2 gps
* boards: set yaw 270 rotation for external ak09916 driver and only start it for the PH21
* drivers: only start ak09916 when icm20948 is not available on a ph21 setup
* Support for armv7-m_dcache control via parameter
The FORCE_F7_DCACHE parameter can be set to
0 - (default) if Eratta exits turn dcache off else leave it on
1 - Force it off
2 - Force it on
At boot the system will disable the d-cache if the silicon
has the 1259864 Data corruption in a sequence of Write-Through
stores and loads eratta.
Post nsh script execution the FORCE_F7_DCACHE paramater
will be used to set the d-cache to the state indicated
above.
The replay functionality was broken with lockstep. This is an interim
fix for the replay functionality.
In the longer term it would be nice to leverage the lockstep speedup
for the replay.
The cause of the stack detection fault is because of the
level of nesting in the start up script. We need to
determine the worst case configuration and set the
bar there.
This fault occurred some 42 calls deep due to script
calling script (repeat).
The HW stack check requires as a margin of 204 bytes. That is
ISR HW stacking of CPU(8) FPU(18) registers and SW stacking of
CPU(11) and FPU(16) registers. Total CPU(19) registers is
68 bytes and the total FPU(34) registers is 136 bytes. On
a system with a separate ISR stack This only needs to be 104
so there is 100 bytes of headroom. But as coded the detection
will give a false positive detection and fault. This does not
mean that the stack will be corrupted.
Adjustments to that stack can have no effect due to rounding.
A stack size of 2608 and 2616 can yield the exact same size stack.
So even when the failure is due to a 4 byte overflow, it can take
greater than a 16 bytes increase to fix it. Because the final
stack size is calculated with an 8 byte alignment after a 4 byte
decrease. So 2624 becomes 2620 at runtime and will boot
with SYS_AUTOSTART=4001.
- see 1259864 Data corruption in a sequence of Write-Through stores and loads
- if we can be certain this sequence won't occur in PX4 then the d-cache will be re-enabled
* The build is built with SPI4. At run time the signal GPIO_8266_GPIO2 it tested. If it is low the SPI4 is configured. If it is high SPI4 is not configured.
* board_common: Add Notion of Board has bus manifest
Beat Küng
Andreas Daniel Antener
Daniel Agar
David Sidrane
Chris Lovett
mcsauder
Julian Oes
Hamish Willee
Vasily Evseenko
fpvaspassion
Mohammed Kabir
DanielePettenuzzo