* commander: send parachute command on termination
This sends the DO_PARACHUTE command to parachute component.
* commander: fix lying comments and printf
* commander: use one flag for termination triggered
This merges the duplicate flags _flight_termination_triggered and
_flight_flight_termination_printed.
* commander: correct variable name
* commander: always send tune with parachute
* commander: fix target_component for parachute cmd
The previous changes were wrong in that all commands were now sent to
the parachute component which doesn't make any sense. Of course only the
parachute command should be sent there.
For historical reasons, there is a check in EKF2 to only publish global
position if it has moved for 1mm.
This is no longer necessary, and also this if doesn't save any cpu cycles
in real conditions where GPS errors are always much bigger that this.
When using simulated or fake GPS, based on some other positioning
system, the GPS coordinate input can be very accurate due to quantization
or true accuracy. In this case this check bites and perfectly valid position
doesn't get published.
Just removed this if.
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
When user override using the RC sticks is allowed, I would expect this
feature to also work in the case where GPS is lost and the vehicle goes
into a blind land/descent.
Without this commit, the vehicle would switch to Land mode and a pilot
could not take over control unless they switch to Altitude control in
a ground station.
With this commit, user override works as I would expect it and it will
switch to Altitude control allowing a pilot to recover in this
situation.
This fixes a tricky bug that we discovered in MAVSDK:
https://github.com/mavlink/MAVSDK/pull/1464
It turns out the target_system and target_component fields can
potentially be:
1. at the end of a message payload,
2. and zero,
and therefore they get trimmed. When you then try to read it you
potentially read some garbage from the CRC fields.
The hrt_abstime value used to control the 1s pub rate was the value of
the timestamp_usec of the CanardTransfer, which has a timeout of 100ms
added to it.
Since hrt_abstime is an unsigned datatype, if the hrt_elapsed_time()
check was called <100ms apart, the negative value would result in a
large hrt_elapsed_time, and the bus would be spammed with Heartbeat
messages (or error messages from canardTxPush).
This logic was introduced to avoid large altitude drifts in velocity
mode (altitude not controlled) due to potential velocity estimate bias
in case of IMU problems (see PR #8445). After some refactorings,
the logic started to be used in altitude-controlled modes as well, which is not needed.
* Update to use libcanard callback
Reworked param system with lambda
* Use callback instead of lambda saves 500 bytes of flash
* [UAVCANv1] Added ServiceRequest class, subscribers decoupled
* PX4 UAVCANv1 portID param default CANARD_PORT_ID_UNSET (65535U)
* [UAVCANv1] uORB sensor_gps modify timestamp for now untill we've got timesync working
* UAVCANv1 update parameter definition to use -1 as unset
Julian Oes
Jukka Laitinen
TSC21
Daniel Agar
Hamish Willee
David Sidrane
Beat Küng
Peter van der Perk
echoG
bresch
JacobCrabill
CUAV_gitfishup
achim
Matthias Grob
CUAVmengxiao
RomanBapst
Silvan Fuhrer