- this is one of the last pieces of the system that still depend on DriverFramework
- add new SIM_GPS_NOISE_X parameter for optionally increasing the GPS noise multiplier (was previously a gpssim command line option)
- add SIM_x_BLOCK parameters to block sensor publication
- SIM_GPS_BLOCK
- SIM_ACCEL_BLOCK
- SIM_GYRO_BLOCK
- SIM_MAG_BLOCK
- SIM_BARO_BLOCK
- SIM_DPRES_BLOCK
This new airspeed module does:
-runns an airspeed validator for every airspeed sensor present, which checks measurement validity and estimates an airspeed scale
-selects another airspeed sensor if for the current one a failure is detected
-estimates airspeed with groundspeed-windspeed if no valid airspeed sensor is present
-outputs airspeed_validated topic
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
When simulating with lockstep we can raise the speed by setting the env
variable `PX4_SIM_SPEED_FACTOR`. Some inputs like RC, MAVLink heartbeats
from a ground station, or offboard controls via MAVLink are still at the
normal speed which leads to timeouts getting detected in PX4.
To work around this issue we can automatically multiply the timeout
parameters by the speed factor.
This way we prevent a big dip due to TECS in altitude when the
transition happens at 10 m/s already. Apparently the rule of thumb
is to set this transition speed at the same as airspeed cruise speed.
Mark V19_VT_ROLLDIR @category system
Throttle down mavlink critical msg
Send 0 actuator_output for safety
VTOL: unset v1.9 roll direction safety check param for builtin airframes
The typhoon has a 6011_typhoon_h480.post script that got matched as well.
Now we exclude all files that contain a dot (apparently it's not so easy
to do generic pattern matching in a portable way, but this works).
This uses the systems default shell:
- Ubuntu: dash
- Fedora: bash
Since bash is invoked via /bin/sh, it operates in POSIX mode:
https://tiswww.case.edu/php/chet/bash/POSIX
- remove '# Ignore the expand_aliases command in zshell.'
Not needed because the shell operates in POSIX mode
- [[ is bashism -> use [
- autostart_files=( $autostart_file_match )
is not supported in dash, so use 'ls'
- shellcheck runs the dash flavor, since dash is a minimalistic shell.
Tested on dash & bash.
Daniel Agar
Lorenz Meier
Julian Oes
RomanBapst
Matthias Grob
Julien Lecoeur
TSC21
JaeyoungLim
Jaeyoung-Lim
BazookaJoe1900
Silvan Fuhrer
Timothy Scott
Fabian Schilling
Beat Küng
Nico van Duijn
Martina Rivizzigno
DanielePettenuzzo
Anthony Lamping
Eric Babyak
bresch
Kunal Shah