You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
45 lines
2.5 KiB
45 lines
2.5 KiB
|
|
uint8 SWITCH_POS_NONE = 0 # switch is not mapped |
|
uint8 SWITCH_POS_ON = 1 # switch activated (value = 1) |
|
uint8 SWITCH_POS_MIDDLE = 2 # middle position (value = 0) |
|
uint8 SWITCH_POS_OFF = 3 # switch not activated (value = -1) |
|
uint64 timestamp |
|
|
|
# Any of the channels may not be available and be set to NaN |
|
# to indicate that it does not contain valid data. |
|
# The variable names follow the definition of the |
|
# MANUAL_CONTROL mavlink message. |
|
# The default range is from -1 to 1 (mavlink message -1000 to 1000) |
|
# The range for the z variable is defined from 0 to 1. (The z field of |
|
# the MANUAL_CONTROL mavlink message is defined from -1000 to 1000) |
|
|
|
float32 x # stick position in x direction -1..1 |
|
# in general corresponds to forward/back motion or pitch of vehicle, |
|
# in general a positive value means forward or negative pitch and |
|
# a negative value means backward or positive pitch |
|
float32 y # stick position in y direction -1..1 |
|
# in general corresponds to right/left motion or roll of vehicle, |
|
# in general a positive value means right or positive roll and |
|
# a negative value means left or negative roll |
|
float32 z # throttle stick position 0..1 |
|
# in general corresponds to up/down motion or thrust of vehicle, |
|
# in general the value corresponds to the demanded throttle by the user, |
|
# if the input is used for setting the setpoint of a vertical position |
|
# controller any value > 0.5 means up and any value < 0.5 means down |
|
float32 r # yaw stick/twist position, -1..1 |
|
# in general corresponds to the righthand rotation around the vertical |
|
# (downwards) axis of the vehicle |
|
float32 flaps # flap position |
|
float32 aux1 # default function: camera yaw / azimuth |
|
float32 aux2 # default function: camera pitch / tilt |
|
float32 aux3 # default function: camera trigger |
|
float32 aux4 # default function: camera roll |
|
float32 aux5 # default function: payload drop |
|
|
|
uint8 mode_switch # main mode 3 position switch (mandatory): _MANUAL_, ASSIST, AUTO |
|
uint8 return_switch # return to launch 2 position switch (mandatory): _NORMAL_, RTL |
|
uint8 rattitude_switch # rattitude control 2 position switch (optional): _MANUAL, RATTITUDE |
|
uint8 posctl_switch # position control 2 position switch (optional): _ALTCTL_, POSCTL |
|
uint8 loiter_switch # loiter 2 position switch (optional): _MISSION_, LOITER |
|
uint8 acro_switch # acro 2 position switch (optional): _MANUAL_, ACRO |
|
uint8 offboard_switch # offboard 2 position switch (optional): _NORMAL_, OFFBOARD
|
|
|