zr-v4/libraries/AP_Motors/AP_MotorsSingle.h

/// @file	AP_MotorsSingle.h
/// @brief	Motor and Servo control class for Singlecopters
#pragma once

#include <AP_Common/AP_Common.h>
#include <AP_Math/AP_Math.h>        // ArduPilot Mega Vector/Matrix math Library
#include <RC_Channel/RC_Channel.h>     // RC Channel Library
#include "AP_MotorsMulticopter.h"

// feedback direction
#define AP_MOTORS_SING_POSITIVE      1
#define AP_MOTORS_SING_NEGATIVE     -1

#define NUM_ACTUATORS 4

#define AP_MOTORS_SINGLE_SPEED_DIGITAL_SERVOS 250 // update rate for digital servos
#define AP_MOTORS_SINGLE_SPEED_ANALOG_SERVOS 125  // update rate for analog servos

#define AP_MOTORS_SINGLE_SERVO_INPUT_RANGE      4500    // roll or pitch input of -4500 will cause servos to their minimum (i.e. radio_min), +4500 will move them to their maximum (i.e. radio_max)

/// @class      AP_MotorsSingle
class AP_MotorsSingle : public AP_MotorsMulticopter {
public:

    /// Constructor
    AP_MotorsSingle(uint16_t loop_rate, uint16_t speed_hz = AP_MOTORS_SPEED_DEFAULT) :
        AP_MotorsMulticopter(loop_rate, speed_hz),
        _servo1(CH_NONE), _servo2(CH_NONE), _servo3(CH_NONE), _servo4(CH_NONE)
    {
        AP_Param::setup_object_defaults(this, var_info);
    };

    // init
    virtual void        Init();

    // set update rate to motors - a value in hertz
    void                set_update_rate( uint16_t speed_hz );

    // enable - starts allowing signals to be sent to motors
    virtual void        enable();

    // output_test - spin a motor at the pwm value specified
    //  motor_seq is the motor's sequence number from 1 to the number of motors on the frame
    //  pwm value is an actual pwm value that will be output, normally in the range of 1000 ~ 2000
    virtual void        output_test(uint8_t motor_seq, int16_t pwm);

    // output_to_motors - sends minimum values out to the motors
    virtual void        output_to_motors();

    // get_motor_mask - returns a bitmask of which outputs are being used for motors or servos (1 means being used)
    //  this can be used to ensure other pwm outputs (i.e. for servos) do not conflict
    virtual uint16_t    get_motor_mask();

    // var_info for holding Parameter information
    static const struct AP_Param::GroupInfo var_info[];

protected:
    // output - sends commands to the motors
    void                output_armed_stabilizing();

    // servo speed
    AP_Int16            _servo_speed;

    RC_Channel          _servo1;
    RC_Channel          _servo2;
    RC_Channel          _servo3;
    RC_Channel          _servo4;

    int16_t             _throttle_radio_output;   // total throttle pwm value, summed onto throttle channel minimum, typically ~1100-1900
    float               _actuator_out[NUM_ACTUATORS]; // combined roll, pitch, yaw and throttle outputs to motors in 0~1 range
    float               _thrust_out;
};