this enables the parameter backup/restore on those boards, as well as
more waypoints
This is in response to a report that CUAVv5 boards can suffer from the
parameter reset issue
this takes better advantage of the new UART code. Log download over
USB gets to 730 kbyte/s. For comparison, with the 4.0 code on the same
H7 we get about 300 kbyte/s
this gains about 20k of RAM, and has almost no impact on log download
speed at 921600 on a F427. The improved threading means we can afford
to have smaller buffers
refactor rcout into separate thread and process all dshot requests there
move uart DMA completion to event model
process dshot locks in strick reverse order when unlocking
convert Shared_DMA to use mutexes
move UART transmit to a thread-per-uart
do blocking UART DMA transactions
do blocking dshot DMA transactions
trim stack sizes
cancel dma transactions on dshot when timeout occurs
support contention stats on blocking locking
move thread supression into chibios_hwdef.py
invalidate DMA bounce buffer correctly
separate UART initialisation into two halves
cleanup UART transaction timeouts
add @SYS/uarts.txt
move half-duplex handling to TX thread
correct thread statistics after use of ExpandingString
set unbuffered TX thread priority owner + 1
correctly unlock serial_led_send()
don't share IMU RX on KakuteF7Mini
observe dshot pulse time more accurately.
set TRBUFF bit for UART DMA transfers
deal with UART DMA timeouts correctly
don't deadlock on reverse ordered DMA locks
change PORT_INT_REQUIRED_STACK to 128
When hw flow control is enabled check the CTS pin before we grab the
DMA channel to prevent a long timeout trying to send to a blocked port
from holding a DMA channel against another device
this fixes issue #16587
Adjust SRAM1+SRAM2 to 256k as describe in the H743 reference manual
Provide access to mem_info() information
Co-authored-by: Andrew Tridgell <andrew@tridgell.net>
Andrew Tridgell
Andy Piper
QioTek
Lava Chemist
Mirko Denecke
mateksys
Michael du Breuil
Michel Pastor
auturgy
huhen
bugobliterator
pkocmoud