this is most often implemented as dual-motor differential thrust, and
we don't want to do surface speed scaling for that.
In the future we'll move this scaling so it can be done on rudders for
3D planes
added scaling of control surfaces by throttle when in hover. This helps
the controller remain stable over a wide range of throttle levels, such
as when descending or rapidly climbing
this gives extra pitch input when taking off a vectored tailsitter,
allowing the motors to point straight up for easy takeoff
thanks to Leonard for the idea!
this adds support for tiltrotors which control yaw by vectoring the
forward motors. This avoids the need for the rear motor on a
tilt-tricopter to have a tilt servo
This adds new parameters Q_TAILSIT_MASK and Q_TAILSIT_MASKCH. These
parameters allow a user to use the tailsitter capabilities of a 3D
plane to teach themselves to prop-hang.
It works by allowing the user to setup a switch on their transmitter
to enable manual pass-thru of a set of the input channels to outputs
when in tailsitter hover. The user can then use that switch to allow
learning of hover control in a 3D plane one channel (or two channels)
at a time.
this allows the user to control tailsitters either in body frame (like
a plane) or in earth frame (like a multicopter). This is useful for
people wanting to learn to fly prop-hang on 3D planes
use both roll and pitch to trigger completion of transition. This
copes with situations where the plane has managed to get itself rolled
over far enough that it can't recover into hover
Randy Mackay
Andrew Tridgell
Mathieu OTHACEHE
Lucas De Marchi
Staroselskii Georgii
Andrew Tridgell
uncrustify
james.goppert