shrank speed filter to avoid latency
removed unused forward estimator code
placed code for switchover to gps.groundspeed at 1.5m/s
added clamp for D term when below .5m/s to eliminate noise
added hybrid I-term based on speed error and position
changes Loiter D term to use position rather than acceleration to avoid noise
Merged CopterLEDS and Piezo functions to eliminate pin conflict on APM2. Created new Parameter bit to turn piezo function on and off from MP. Moved GPS and Aux pin assignments to allow commonality between APM1 and 2. Set LED_Mode parameter default to 9 in order to make CopterLEDS completely backwards compatible with old Motor LEDS and Piezo code. Legacy users should see no difference.
Added option (hold roll to full right + SW7 ON/OFF) to init_home during the wp_list reset
Add ROV_SONAR_TRIG (default = 200 cm) - tested by Franco
Restart_nav() added and heading bug correction, tested OK in the field
RTL then stop update - Tested OK in the field
Added SONAR detection for obstacle avoidance
Signed-off-by: Jean-Louis Naudin <jlnaudin@gmail.com>
work on opengltest
fix last missing param
fix com port selection on connecting to bad comport
add convert to csv. entire log
add log caching to image georef. for tlog and logs
add srtm data caching
Extended AP_MotorsTri class to take in pointer to rc_tail servo (rc_7) and we use this servo's REV parameter to determine whether to reverse the output to the tail servo or not
building with TELEMETRY_UART2=ENABLED allows you to use the solder
bridge on the APM2 to enable telemetry on UART2. This allows both USB
telemetry and a radio at the same time.
our git tree has become far too large due to large exe, dll etc
files. We can't fully get rid of the ones that are there, but this may
discourage people from adding more
Andrew Tridgell
Michael Oborne
Jason Short
Robert Lefebvre
Hazy
Jean-Louis Naudin
Michael Oborne
rmackay9
Craig Elder
Chris Anderson