3a8ed06267
Copter: added TKOFF_NAV_ALT parameter
...
this adds TKOFF_NAV_ALT which controls the altitude above takeoff that
navigation can begin. It is meant for unstable vehicles such as helis
to prevent blade strike during initial takeoff.
This also adds a new parameter class ParametersG2 which can hold 64
parameters. This is to avoid running out of parameters in the first
256 block
9 years ago
877a144dea
Copter: pre-arm check that rally points are within fence
9 years ago
2647bed484
Copter: guided mode uses modified check_destination_within_fence
9 years ago
91a5b26725
Copter: use simplified precland interface
9 years ago
7fddf20f0b
Copter: enable precision landing in auto mode
9 years ago
543d5701e7
Copter: remove unused log_write_startup
9 years ago
5d5a85c38e
Copter: log rally points on startup
9 years ago
6737bc21b9
Copter: fixed typo
9 years ago
b5ccd458d3
Copter: added 10Hz logging of controller RMS values
...
as discussed with Leonard
9 years ago
7edb6e76f0
Copter: set terrain capabilities only if terrain code is compiled in
...
Thanks to OXINARF for finding this
9 years ago
52d81f630f
Copter: pass polygon fence mavlink messages to fence
9 years ago
b61ae1a4a1
Copter: log EKF yaw reset event
9 years ago
07cadc7ddd
Copter: rename limit_angle_to_rate_request to use_input_shaping
9 years ago
3b7658c502
Copter: land and crash detector use thrust angle error
...
The thrust angle error is the difference between our desired thrust vector
and the actual thrust vector
Also some changes to use definitions in place of constants in the checks
9 years ago
7d54c268f6
Copter: consolidate input_euler_angle calls to use smoothing gain
...
Previously we had _smooth and non-smooth methods in the attitude
controller but as part of the move to quaternions these have been replaced
by a single call which always takes a smoothing gain
9 years ago
75c4367cfc
Copter: Change fabs to fabsf
9 years ago
043b1d321d
Copter: remove paths for documenation for non-multi frame
...
Our current documentation system only emits one XML document (apm.pdef.xml)
for ArduCopter.
Since there is a conflict between parameters in the MOT_ namespace in Copter,
we only emit the documentation for the first parameter defining the MOT_ namespace.
This patch removes the documentation lines for frame types other than multicopter, meaning the documentation will reflect mutlictopter usage - the most common case.
These lines will need to be reinstated when we change the way we produce the xml documentation.
9 years ago
7742503ef3
Copter: include AC_AttitudeControl parameter documentation
9 years ago
87be8daf0e
Copter: integrate AC_Avoidance library
9 years ago
5022a45495
Copter: add AC_Avoidance to build
9 years ago
66d4caeeb0
Copter: add ADSB_streamrate
9 years ago
9864750336
Copter: rename CTUN desired_velocity to target_velocity
...
No functional change
9 years ago
a614a17b3a
Copter: log hover throttle in CTUN message
9 years ago
901e8cc23f
Copter: convert THR_MIN to MOT_SPIN_MIN, THR_MID to MOT_THST_HOVER
9 years ago
48eb4cf674
Copter: remove THR_MID
9 years ago
e9d8a28ec0
Copter: AP_Motor's throttle_hover replaces throttle_average
9 years ago
dec9323127
Copter: remove THR_MIN
...
Equivalent is AP_Motors SPIN_MIN
9 years ago
6a1bdebf25
Copter: remove THR_MAX definition for changing throttle input range
...
We do not support changing the throttle input range from it's expected 0 ~ 1000
9 years ago
e08e112c6d
Copter: land detector sets att vs thr priority in att controllers
9 years ago
86d8450666
Copter: use loop rate for copter
...
this allows for SCHED_LOOP_RATE below 400 in SITL for copter
9 years ago
1fc4063117
Copter: correct TERRAIN_FOLLOW parameter comments
9 years ago
55ad1548e4
Copter: fixed heli rotor speed control from AP_Motors refactor
9 years ago
a96abde4bf
Copter: do not log CURR.Throttle because it's already logged elsewhere
9 years ago
b433250da5
Copter: sanity check gps latlng
9 years ago
2815af81ad
Copter: rename RTL_CONE_SLOPE_DEFAULT definition
...
Also tiny formatting fix
9 years ago
e977d85e0c
Copter: move telemetry_delayed up into base class
9 years ago
3cf174c343
Copter: move adjust_rate_for_stream up
9 years ago
bb19c57615
Copter: subclass GCS_MAVLink in place of defining its functions for it
9 years ago
5fb6e4edae
Copter: 3.4-rc1 release notes
9 years ago
be3b1cb6ab
Copter: convert STB_ params to ATC_ANG_
9 years ago
53fc095d4c
Copter: fixed motor test build on heli
...
pwm percent makes no sense
9 years ago
c605f09859
Copter: fixed motor test with percentage
...
use motors min/max pwm, not throttle channel range
9 years ago
146a59eed3
Copter: fixed ESC calibration on PixRacer
...
we need to set the ESC scaling before we go into the calibration loop
or the outputs will never arm
9 years ago
045e3c179a
Copter: moved EKF2 to a new parameter index
...
the meanings of many of the parameters have changed. Best to use a new
index to prevent old parameters from causing crashes
9 years ago
cb9ca94dd1
Copter: remove unused pv_location_to_vector_with_default
9 years ago
390d06a400
Copter: add and use FLIP_COMPLETE mode reason
...
No need to use the original reason we entered flip mode as the reason we are exiting flip. Instead we can use a new reason called FLIP_COMPLETE
9 years ago
7e1ef905d3
Copter: removed 30ms delay on arming
...
this is the last of the delays that can cause the EKF to get unhappy
on arming in copter. The comment says it is waiting for RC input, but
I don't think that makes any sense any more.
9 years ago
c9284e5f64
Copter: fix flip after throttle changed to 0 to 1 range
9 years ago
f28666e7cd
Copter: pass throttle for esc calibration in 0 to 1 range
9 years ago
33f5fc5f38
ArduCopter: remove support for flymaple
9 years ago
Andrew Tridgell
Randy Mackay
Jonathan Challinger
Derek Ma
Leonard Hall
Peter Barker
Daniel Ricketts
Tom Pittenger
Lucas De Marchi