You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
28 lines
981 B
28 lines
981 B
// HIL_MODE SELECTION |
|
// |
|
// Mavlink supports |
|
// 1. HIL_MODE_SENSORS: full sensor simulation |
|
#define HIL_MODE HIL_MODE_SENSORS |
|
|
|
// HIL_PORT SELCTION |
|
// |
|
// PORT 1 |
|
// If you would like to run telemetry communications for a groundstation |
|
// while you are running hardware in the loop it is necessary to set |
|
// HIL_PORT to 1. This uses the port that would have been used for the gps |
|
// as the hardware in the loop port. You will have to solder |
|
// headers onto the gps port connection on the apm |
|
// and connect via an ftdi cable. |
|
// |
|
// The baud rate is set to 115200 in this mode. |
|
// |
|
// PORT 3 |
|
// If you don't require telemetry communication with a gcs while running |
|
// hardware in the loop you may use the telemetry port as the hardware in |
|
// the loop port. Alternatively, use a telemetry/HIL shim like FGShim |
|
// https://ardupilot-mega.googlecode.com/svn/Tools/trunk/FlightGear |
|
// |
|
// The buad rate is controlled by SERIAL1_BAUD in this mode. |
|
|
|
#define HIL_PORT 3 |
|
|
|
|