You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
50 lines
1.5 KiB
50 lines
1.5 KiB
// -*- tab-width: 4; Mode: C++; c-basic-offset: 4; indent-tabs-mode: t -*- |
|
|
|
/// @file AP_MotorsTri.h |
|
/// @brief Motor control class for Tricopters |
|
|
|
#ifndef __AP_MOTORS_TRI_H__ |
|
#define __AP_MOTORS_TRI_H__ |
|
|
|
#include <AP_Common.h> |
|
#include <AP_Math.h> // ArduPilot Mega Vector/Matrix math Library |
|
#include <RC_Channel.h> // RC Channel Library |
|
#include "AP_Motors.h" |
|
|
|
// tail servo uses channel 7 |
|
#define AP_MOTORS_CH_TRI_YAW CH_7 |
|
|
|
/// @class AP_MotorsTri |
|
class AP_MotorsTri : public AP_Motors { |
|
public: |
|
|
|
/// Constructor |
|
AP_MotorsTri( RC_Channel* rc_roll, RC_Channel* rc_pitch, RC_Channel* rc_throttle, RC_Channel* rc_yaw, RC_Channel* rc_tail, uint16_t speed_hz = AP_MOTORS_SPEED_DEFAULT) : |
|
AP_Motors(rc_roll, rc_pitch, rc_throttle, rc_yaw, speed_hz), |
|
_rc_tail(rc_tail) { |
|
}; |
|
|
|
// init |
|
virtual void Init(); |
|
|
|
// set update rate to motors - a value in hertz |
|
void set_update_rate( uint16_t speed_hz ); |
|
|
|
// enable - starts allowing signals to be sent to motors |
|
virtual void enable(); |
|
|
|
// motor test |
|
virtual void output_test(); |
|
|
|
// output_min - sends minimum values out to the motors |
|
virtual void output_min(); |
|
|
|
protected: |
|
// output - sends commands to the motors |
|
virtual void output_armed(); |
|
virtual void output_disarmed(); |
|
|
|
RC_Channel* _rc_tail; // REV parameter used from this channel to determine direction of tail servo movement |
|
}; |
|
|
|
#endif // AP_MOTORSTRI
|
|
|