| .. |
|
APM_Config.h
|
Plane: added HIL_MODE parameter
|
10 years ago |
|
APM_Config.h.reference
|
Plane: cleanup HIL defines
|
11 years ago |
|
ArduPlane.cpp
|
Plane: abort landing at 90% throttle instead of 95%
|
9 years ago |
|
Attitude.cpp
|
Plane: make throttle_percentage() signed
|
9 years ago |
|
GCS_Mavlink.cpp
|
Plane: add SYS_STATUS reverse_motor
|
9 years ago |
|
Log.cpp
|
Plane: make throttle signed (pos and neg)
|
9 years ago |
|
Makefile
|
Plane: cleanup cruft in Makefile
|
11 years ago |
|
Makefile.waf
|
waf: use single entry point for make wrappers
|
9 years ago |
|
Parameters.cpp
|
Plane: param desc to increase THR_MIN range to include negative thrust
|
9 years ago |
|
Parameters.h
|
Plane: Reverse Thrust
|
9 years ago |
|
Parameters.pde
|
Plane: added blank Parameters.pde for MissionPlanner
|
10 years ago |
|
Plane.cpp
|
AP_HAL: make code not depend on concrete HAL implementations
|
9 years ago |
|
Plane.h
|
Plane: Reverse Thrust
|
9 years ago |
|
adsb.cpp
|
Plane: refactored interface
|
9 years ago |
|
altitude.cpp
|
Plane: add flight stage LAND_PREFLARE
|
9 years ago |
|
arming_checks.cpp
|
Plane: restrict rudder arming where reverse_thrust is enabled and commanding negative
|
9 years ago |
|
capabilities.cpp
|
Plane: init vehicle capabilities
|
10 years ago |
|
commands.cpp
|
Plane: Text revisions
|
9 years ago |
|
commands_logic.cpp
|
Plane: Reverse Thrust
|
9 years ago |
|
commands_process.cpp
|
Plane: convert from .pde to .cpp files
|
10 years ago |
|
config.h
|
ArduPlane: remove check for AVR CPUs
|
9 years ago |
|
control_modes.cpp
|
Plane: added OVERRIDE_SAFETY parameter
|
9 years ago |
|
createTags
|
ArduPlane: don't use avr include dir for tags
|
9 years ago |
|
defines.h
|
Plane: Reverse Thrust
|
9 years ago |
|
events.cpp
|
Plane: add flight stage LAND_PREFLARE
|
9 years ago |
|
failsafe.cpp
|
Plane: require 5 channels to run failsafe passthrough
|
10 years ago |
|
geofence.cpp
|
ArduPlane: avoid comparison between signed and unsigned
|
9 years ago |
|
is_flying.cpp
|
Plane: run is_crashed at 5hz instead of 1hz
|
9 years ago |
|
landing.cpp
|
Plane: Reverse Thrust
|
9 years ago |
|
make.inc
|
Plane: added QLOITER mode
|
9 years ago |
|
navigation.cpp
|
Plane: added parameter RTL_RADIUS
|
9 years ago |
|
parachute.cpp
|
Plane: Text revisions
|
9 years ago |
|
px4_mixer.cpp
|
Plane: Only resend the mixer configuration if its changed
|
9 years ago |
|
quadplane.cpp
|
Plane: support all types of multicopters in quadplane
|
9 years ago |
|
quadplane.h
|
Plane: support all types of multicopters in quadplane
|
9 years ago |
|
radio.cpp
|
Plane: restrict rudder arming where reverse_thrust is enabled and commanding negative
|
9 years ago |
|
release-notes.txt
|
Plane: prepare for 3.5.0 release
|
9 years ago |
|
sensors.cpp
|
Plane: add flight stage LAND_PREFLARE
|
9 years ago |
|
setup.cpp
|
Replace use of UARTDriver::printf_P() with UARTDriver::printf()
|
9 years ago |
|
system.cpp
|
Plane: make throttle_percentage() signed
|
9 years ago |
|
takeoff.cpp
|
Plane: zero course error for straight bungee launch
|
9 years ago |
|
test.cpp
|
Plane: allow for settable main loop rate
|
9 years ago |
|
wscript
|
waf: ardupilotwaf: prefix build context methods with ap_
|
9 years ago |
Tom Pittenger
d04b5e735f