You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
70 lines
1.6 KiB
70 lines
1.6 KiB
# hw definition file for processing by chibios_hwdef.py |
|
# for bootloader for FMUv4pro hardware (Pixhawk 3 Pro) |
|
|
|
# MCU class and specific type |
|
MCU STM32F4xx STM32F469xx |
|
|
|
# board ID for firmware load |
|
APJ_BOARD_ID 13 |
|
|
|
# crystal frequency |
|
OSCILLATOR_HZ 24000000 |
|
|
|
# board voltage |
|
STM32_VDD 330U |
|
|
|
# ChibiOS system timer |
|
STM32_ST_USE_TIMER 5 |
|
|
|
# flash size |
|
FLASH_SIZE_KB 2048 |
|
|
|
# location of application code |
|
FLASH_BOOTLOADER_LOAD_KB 16 |
|
|
|
# bootloader loads at start of flash |
|
FLASH_RESERVE_START_KB 0 |
|
|
|
# uarts and USB to run bootloader protocol on |
|
UART_ORDER OTG1 USART2 USART3 |
|
|
|
# this is the pin that senses USB being connected. It is an input pin |
|
# setup as OPENDRAIN |
|
PA9 VBUS INPUT OPENDRAIN |
|
|
|
# now we define the pins that USB is connected on |
|
PA11 OTG_FS_DM OTG1 |
|
PA12 OTG_FS_DP OTG1 |
|
|
|
# these are the pins for SWD debugging with a STlinkv2 or black-magic probe |
|
PA13 JTMS-SWDIO SWD |
|
PA14 JTCK-SWCLK SWD |
|
|
|
# Another USART, this one for telem1 |
|
PD5 USART2_TX USART2 |
|
PD6 USART2_RX USART2 |
|
PD3 USART2_CTS USART2 |
|
PD4 USART2_RTS USART2 |
|
|
|
# the telem2 USART, also with RTS/CTS available |
|
# USART3 serial3 telem2 |
|
PD8 USART3_TX USART3 |
|
PD9 USART3_RX USART3 |
|
PD11 USART3_CTS USART3 |
|
PD12 USART3_RTS USART3 |
|
|
|
# define a LED |
|
PB1 LED_BOOTLOADER OUTPUT |
|
PB11 LED_ACTIVITY OUTPUT |
|
define HAL_LED_ON 1 |
|
|
|
# we need to tell HAL_ChibiOS/Storage.cpp how much storage is |
|
# available (in bytes) |
|
define HAL_STORAGE_SIZE 16384 |
|
|
|
# uncomment the lines below to enable strict API |
|
# checking in ChibiOS |
|
# define CH_DBG_ENABLE_ASSERTS TRUE |
|
# define CH_DBG_ENABLE_CHECKS TRUE |
|
# define CH_DBG_SYSTEM_STATE_CHECK TRUE |
|
# define CH_DBG_ENABLE_STACK_CHECK TRUE
|
|
|